User manual PALSONIC MODEL 6830TG

[. . . ] The exact type and position of the aerial will depend upon your particular area. RF Notes: It is recommended that the 75-ohm coaxial cable be used to eliminate interference and noise which may occur due to radio wave conditions. The aerial cable should not be bundled with the power cord and the like. INSTALL the unit in a room where direct light will not fall upon the screen. Total darkness or a reflection on the picture screen may cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. 6 Installation Installing batteries Effective range of the Remote Open the battery cover. Install two "AAA" batteries matching the +/- polarities of the battery to the +/marks inside the battery compartment. M 5m ? i 1 4 7 2 5 8 0/AV CH VOL VOL 3 6 9 --/--- + CH + - HOTEL S. M P. M LOCK + SOUND + + Replace the battery cover. Notes: When there is an obstacle between the TV and the transmitter, the transmitter may not operate. [. . . ] Sound 2 Press CH+ or CH- to select P+ desired adjusting item. + SOUND + 3 Press VOL+/- to adjust the level. P- Volume Bass Treble Balance DBE MSS Off Off - + + Item Volume Bass Treble Balance DBE (Dynamic bass enhanced) MSS (Micronas surround sound) VOLweaker weaker weaker decrease the right channel VOL+ stronger stronger stronger decrease the left channel ON/OFF ON/OFF The adjusted level is stored in the Favourite position. Note: DBE/MSS function are optional function. 21 Sound controls Sound mode selection You can select the sound quality instantly among three preset modes and one user-set mode. Movie, Music, Speech and Favourite (user-set) can be selected cyclically. Sound mode Movie Sound mode Music Sound mode Speech Sound mode Favourite ? i Enter into earphone state 1 4 7 2 5 8 0/AV CH VOL VOL 3 6 9 --/--- CH + - O Sound quality Mode like a movie theatre filled with a dynamic sound Movie like a music hall filled with a rich warm sound. Music Suitable for listening to news/dialogue Speech the sound quality you set Favourite + M EN U HOTEL S. M P. M K To enter into earphone state LOCK SM (sound mode select) + + SOUND In this model, if you press button and enter into earphone state, the sound is muted and the icon is shown on the screen. Press the button again to restore. + * To exit the menu, press OK button. 22 Timer setting Setting clock 1 Press MENU button repeatedly to display Timer menu. ? i 2 3 3 6 9 --/--- Timer Press CH+/- to select Clock. If wrong in setting the time, press RED button to cancel and input again. P+ Clock Timer off Timer on Timer set Prog no P- 10:01 --:---:---:-3 1 4 7 2 5 8 0/AV + CH VOL VOL x - + Digit buttons MENU CH+/(menu item select) VOL+/(menu item adjust) K Notes: Before setting the timer, please first set the CLOCK item. Press the main power switch to turn off the set, the clock will be cancelled. You need to reset it if you want to use the timer function. CH + - O * To exit the menu, press OK button. M EN U HOTEL S. M To turn off TV automatically (OFF timer) With the OFF timer, the TV will automatically switch to standby mode at a preset time. LOCK P. M OK (exit the menu) RED button + SOUND + 1 2 In Timer menu, press CHto select Timer off. In wrong in inputting, press RED button to cancel and input again. Timer P+ Clock Timer off Timer on Timer set Prog no P- 10:02 23:00 --:---:-3 x - + + At the preset time, the TV will go into standby mode automatically. Once the OFF timer has been fulfilled, next when you want to use it, you should reset it again. 23 Timer setting To turn on the TV automatically (ON timer) (On/standby) With the ON timer, the TV will automatically turn on to a preset channel at a preset time. 1 In Timer menu, press CH- to select Timer on. Timer P+ ? i 2 Use Digit Buttons to set ON 3 6 9 --/--- 1 4 7 time. If wrong in inputting, press RED button to cancel and input again. Clock Timer off Timer on Timer set Prog no P- 10:02 12:00 14:05 --:-5 2 5 8 0/AV + CH VOL VOL 3 Press CH- to select Prg no. , Digit buttons x - + use VOL+/- to set the ON program, or you can directly input the number by digit buttons. MENU CH+/(menu item select) VOL+/menu item adjust) K 4 Press STANDBY ( ) button to switch the TV to standby mode. At the preset time, the TV will turn on to the preset program automatically. Once the ON timer has been fulfilled, next when you want to use it again, you should reset it. CH + - HOTEL S. M P. M LOCK O * To exit the menu, press OK button. M EN U OK (exit the menu) RED button To switch the TV to a program at a preset time + SOUND + 1 In Timer menu, press CH+/to select Timer set. P+ Timer Clock Timer off Timer on Timer set Prog no P- 2 + Use Digit buttons to set the time. use VOL+/- to set a program number, or directly input the number by digit buttons. At the preset time, the TV will automatically switch to the preset program. 10:05 23:00 --:-18:00 2 x Timer - + 3 Press CH- to select Prg no. , P+ Clock Timer off Timer on Timer set Prog no P- 10:06 23:00 --:-18:00 14 x - + Note: When you turn off the TV by main power switch, all functions in Timer menu will be cancelled. 24 Special functions To select OSD language There are multi OSD languages in this TV set provided for you to select (OSD: on-screen display): 1 ? Press MENU repeatedly to display Special functions menu. Special functions Now the first menu item is highlighted and indicates the current selected OSD language. (if in English it will display ENGLISH). P+ 2 i English Language On Blue back 50 Rotate Off Child lock Auto Color system B/G Sound system P- 1 4 7 2 5 8 0/AV + CH VOL VOL 3 6 9 --/--- - 3 1 2 3 + Press VOL+/- to select a proper OSD language. Setting blue back Enter into Special functions menu Press CH+/- to select Blue back. Press VOL+/- to turn on/off blue back. P+ MENU CH+/(menu item select) VOL+/(menu item adjust) K Special functions English Language On Blue back 50 Rotate Off Child lock Auto Color system B/G Sound system CH + - O * To exit the menu, press OK button. M EN U HOTEL S. M P- - + LOCK P. M OK (exit the menu) If the Blue back is turned on, the TV will appear a blue back on the screen when there is no input signal. + SOUND Rotate function (option)* + When you switch on your TV there may be a slight tilt of the picture to the left or right. This is due to the earth's magnetic field or position of your TV. To rectify, you can do the following: Screen aspect select + 1 2 3 Enter into Special functions menu. Press VOL+/- to rotate the picture until you are satisfied. P+ Special functions English Language On Blue back 30 Rotate Off Child lock Auto Color system B/G Sound system P- - + Note: Rotation function is an optional function. It is only available in certain versions. 25 Child lock setting * Child lock is an optional function. Child lock setting Making use of child lock function, you can lock all the programs to prevent children from viewing them. 1 ? Press LOCK button on the remote control, the Lock menu bar appears. [. . . ] Only some buttons have function while others can not act, and the volume is limited. TV cabinet creaks Remote controller does not work Unevenness in colour in some parts of the screen 29 Troubleshooting Guide Reception disturbances Most types of television interference can be remedied by adjusting the height and position of the VHF/UHF antenna. If one of these symptoms appear when the TV is connected to a Cable TV system, the disturbance may be caused by the local cable company broadcast. IGNITION: Black spots or horizontal streaks may appear, picture, may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electric drills and other electric appliances. GHOSTS: Ghosts are caused by the television signal following two paths. [. . . ]