User manual PANASONIC CQ-DFX338EW

[. . . ] (attenuation) [VOL #]: No sound. Balance and Fader You can adjust the sound balance among the front, rear, right and left speakers. Default: BAL (balance) CNT (center) FAD (fader) CNT (center) Setting range: 15 levels each Select Select Muting or Attenuation You can select MUTE or ATTENUATION when [MUTE] is pressed. Default: MUTE Select 20 CQ-DFX338EW CQ-DFX338EW 21 E N G L I S H 13 Function Settings E N G L I S H 14 1 Press and hold [SEL] 2 Press [SEL] (select). (select) for more than 2 seconds. (Push. ) 3 Turn [VOL]. [#] ["] Security Function Security Function The security indicator blinks when the removable face plate is removed from the unit. Select [#]: Security function is non-active. When the key in the ignition is turned OFF. [. . . ] The unit may not successfully play back a CD-R/RW that was made by the combination of writing software, a CD recorder (CD-R/RW drive) and a disc if they are incompatible one another. This player cannot play the CD-R/RW discs if the session is not closed. This player cannot play the CD-R/RW discs which contains other than CD-DA. Be sure to observe the instructions of CD-R/RW disc for handling it. Notes on CD/CD Media (CD-R, CD-RW) If you use commercial CDs, they must have the label below. E N G L I S H 20 How to hold the disc Do not touch the underside of the disc. Label side Do not use irregularly shaped discs. Maintenance Your product is designed and manufactured to ensure a minimum of maintenance. Never use benzine, thinner or other solvents. Replacing the Fuse Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting the unit directly without a fuse, could cause fire or damage to the unit. If the replacement fuse fails, contact your nearest Panasonic service station for service. Do not leave discs on the following places: Direct sunlight Near car heaters Dirty, dusty and damp areas Seats and dashboards Disc cleaning Use a dry, soft cloth to wipe from the center outward. <Right> <Wrong> Product Servicing If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized Panasonic service station. The product should be serviced only by a qualified technician. Do not attach any seals or labels to your discs. Do not write on the disc label in a heavy pen or ballpoint pen stroke. 28 CQ-DFX338EW CQ-DFX338EW 29 E N G L I S H 21 Installation Guide WARNING This installation information is designed for experienced installers and is not intended for non-technical individuals. Lower or higher impedance speakers will affect output and can cause both speaker and stereo unit damage. Motor Antenna Connect the car motor antenna lead to the dark blue motor antenna relay control lead. (Do not confuse the antenna lead with blue/white stripe lead for a power amplifier. ) Battery Connect the yellow battery lead to the correct radio wire or to the battery fuse port on the fuse block. Antenna Connect the antenna by plugging the antenna lead into the antenna receptacle. Equipment Connect any optional equipment such as an amplifier, according to the instructions furnished with the equipment. Leave about 30 cm of distance between the speaker leads/amplifier unit and the antenna/antenna extension cord. Read the operating and installation instructions of any equipment you will connect to this unit. Power Connect the red power lead to the correct car radio wire or to the appropriate fuse port on the fuse block. If the stereo unit functions properly with all these connections made, disconnect the wires and proceed to the final installation. Final Checks 1. Make sure that the stereo unit is securely held in the mounting collar. If you have difficulties, consult your nearest authorized professional installer for assistance. Installation Procedures First complete the electrical connections, and then check them for correctness. [. . . ] The dashboard should be 4. 75 mmj5. 56 mm thick in order to be able to support the unit. Final Installation Lead Connections Connect all wires, making sure that each connection is insulated and secure. Bundle all loose wires and fasten them with tape so they will not fall down later. After making a few final checks, you're ready to enjoy your new auto stereo system. 5 Mounting bolt 1 Mounting collar 32 CQ-DFX338EW CQ-DFX338EW 33 E N G L I S H 25 Installation Guide (continued) Remove the Unit Switch off the power of the unit. [OPEN] Anti-Theft System This unit is equipped with a removable face plate. [. . . ]