User manual PANASONIC CQ-DFX444

[. . . ] The first 10 seconds of each track on all discs plays in sequence. E N G L I S H 18 Press [REPEAT]. Press [SCAN] again to cancel. 1 CD Changer Mode (When a CD changer is connected and a magazine is in the changer. ) Press [SOURCE] to change to CD changer mode. Note: Load a magazine with CDs. CD changer mode display Lights when the changer is connected. Changer 1 (This lights only when the dual changer conDisc number trol unit is connected. ) Disc Repeat Play Press and hold [REPEAT] for more than 2 seconds. [. . . ] (page 45) CQ-DFX683U CQ-DF583U Poor recording quality, sound skipping. Disc is not ejected. CQ-DFX683U CQ-DF583U CD text is not displayed normally. Files are not played in the desired order. Time is counted but no sound comes out. An attempt has been made to play a mixed disc. In the case of mixed discs, MP3 files may be played with their sound muted. CQ-DFX444 Folder/file name is not displayed correctly. An attempt has been made to play a regular CD-ROM disc. Insert a CD-DA disc. File playing time is not displayed correctly. 40 CQ-DFX683/DF583/DF203U CQ-DFX683/DF583/DF203U 41 E N G L I S H 27 Troubleshooting (continued) Sound Setting Trouble Cause/Step Left and right balance, or front and rear balance is off on one side. Connect the speaker wires to the correct ones. The model CQ-DFX444 does not support MP3/WMA playback. Error Display Messages CD/MP3/WMA CD CQ-DFX444 Display CQ-DFX683U CQ-DF583U E N G L I S H 28 No sound from left, right, front or rear speaker. Cause/Step Left and right sounds are reversed in stereo listening. Disc is dirty, or is upside down. Check the disc. Remote Control Unit Trouble Battery polarities are reversed. Check the disc. Buttons are invalid for operation. No operation by some cause. If normal operation is not restored, call the store where you purchased the unit or the nearest Servicenter to ask for repairs. MP3/WMA § The player for some reason cannot read the file you are trying to play. (File recorded in an unsupported file system, compression scheme, data format, file name extension, damaged data, etc. ) Select a file that the player can read. This player cannot play the CD-R/RW discs if the session is not closed. This player cannot play the CD-R/RW discs which contains other than CD-DA (or MP3/WMA data CQ-DFX683U CQ-DF583U ). Be sure to observe the instructions of CD-R/RW disc for handling it. Notes on CD/CD Media (CD-ROM, CD-R, CD-RW) If you use commercial CDs, they must have either of these labels below. E N G L I S H 30 How to hold the disc Do not touch the underside of the disc. Caution: This unit operates with a 12 V DC negative ground auto battery system only. Before you begin installation, look for the items which are packed with your unit. Panasonic Servicenter List for Service Directory . . . Keep for future reference in case the product needs servicing. Installation Hardware. . . Needed for in-dash installation. Turn the ignition on to the accessory position, and ground one lead of the test bulb to the chassis. Touch the other lead of the test bulb to each of the exposed wires from the cut radio connector plug. Touch one wire at a time until you find the outlet that causes the test bulb to light. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for radio (RADIO), accessory (ACC), or ignition (IGN). Battery Lead If your stereo unit has a yellow lead, you will need to locate the car's battery lead. (The yellow battery lead provides continuous power to maintain a clock, memory storage, or other function. ) If your car has a radio or is pre-wired for one: With the ignition and headlights off, identify the car battery lead by grounding one lead of the test bulb to the chassis and checking the remaining exposed wires from the cut radio connector plug. Connect All Leads Now that you have identified all the wires in the car, you are ready to begin connecting them to the stereo unit wires. The wiring diagram (page 52) shows the proper connections and color coding of the leads. We strongly recommend that you test the unit before making a final installation. [. . . ] Place the face plate into the case and take it with you when you leave the car. 7 Removable face plate case 2 Push. 3 Pull it out toward you. out. Install Removable Face Plate 1 Fit the face plate with its left hole on one of the Contact 2 Remove the trim plate 8 with a screwdriver. Screwdriver pins provided on the main unit. 8 Trim plate 2 Fit the other hole on the other pin applying slight pressure. 3 1 2 3 Move the face plate up and down a few times to make sure it is secure. Then close the front panel and press down the right side of the face plate until it clicks into plate. plates 3 1 Insert the lock cancelsides of 9 along the grooves on both the main unit until "click" is heard. 1 Insert. Insert the tab end in the outer groove. [. . . ]