User manual PANASONIC CQ-RDP930

[. . . ] All illustrations throughout this manual represent model CQ-C1121U unless otherwise specified. The following table describes the differences among 3 models. General Power supply Current consumption Maximum power output : 12 V DC (11 - 16 V DC), negative ground : Less than 2. 2 A (CD mode; 0. 5 W 4 channels) : 50 W x 4 (at 1 kHz), volume control maximum (for CQ-C1121/C1101U) : 45 W x 4 (at 1 kHz), volume control maximum (for CQ-RDP930) : Bass: ±12 dB at 100 Hz, Treble: ±12 dB at 10 kHz :4 - 8 : 2. 5 V (CD mode, 1 kHz, 0 dB) : 200 : 178 x 50 x 160 mm {7" x 1 15/16" x 6 5/16"} : 1. 3 kg {2 lbs. 14 oz} FM Stereo Radio Frequency range Usable sensitivity 50 dB quieting sensitivity Frequency response Alternate channel selectivity Stereo separation Image response ratio IF response ratio Signal/noise ratio : 87. 9 MHz­107. 9 MHz : 11. 0 dBf. (75 ) : 30 Hz­15 kHz (±3 dB) : 75 dB : 35 dB (1 kHz) : 75 dB : 100 dB : 62 dB CQ-C1121U/C1101U/C1001U Operating Instructions BAND APM U. S. A. PANASONIC CONSUMER ELECTRONICS COMPANY, DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA One Panasonic Way, Secaucus, New Jersey 07094 PANASONIC SALES COMPANY, DIVISION OF MATSUSHITA ELECTRIC OF PUERTO RICO, INC. [. . . ] FAILURE TO FOLLOW THE PROCEDURE MAY LEAD TO THE UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETY SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY OR DEATH. Do not expose the unit to direct sunlight or excessive heat. Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit. Wear gloves for safety. To prevent damage to the unit, do not connect the power connector until the whole wiring is completed. (except for connecting to a tweeter) Do not use the product where it is exposed to water, moisture, or dust. Exposure of the unit to water, moisture, or dust may lead to smoke, fire, or other damage to the unit. Make especially sure that the unit does not get wet in car washes or on rainy days. Clock display Observe the following cautions when handling the battery for the remote control unit. Use only specified battery (CR2025). Match the polarity of the battery with the (+) and (­) marks in Replace dead battery as soon as possible. Remove the battery from the remote control unit when not using Insulate the battery (by placing them in a plastic bag or covering Dispose of the battery according to the local regulations. the battery case. Hold down [DISP] (CLOCK) for more than 2 seconds. Anti-Theft System This unit is equipped with a removable face plate. ¡ Do not place the face plate on the dashboard or nearby areas where the temperature rises high. ¡ Do not touch the contacts on the face plate and the main unit, since this may result in poor electrical contact. ¡ If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth. Observe the following cautions when installing. Refer wiring and installation to qualified service personnel. Installation of this unit requires special skills and experience. Panasonic is not liable for any problems resulting from your own installation of the unit. Use the proper power supply. This product is designed for operation with a negative grounded 12 V DC battery system. (Hold down it for more than 2 seconds to memorize the current station. ) Remote Control Sensor Radio Mode Display [VOLUME] [VOLUME] (Press) adjusts the volume. [BAND] selects a band in the radio source. (Hold down it for more than 2 seconds) [D·M] (Direct Memory) tunes into the station memorized in D·M. (Hold down it for more than 2 seconds to memorize the current station. ) lights while receiving an FM stereo signal. Frequency Band Preset Number Display change Press [DISP] (Display) to change the display. CQ-C1121U CQ-C1101U BAND VO L [VOL] selects a value in the audio menu. (PUSH SEL) (Push to Select) selects items in the audio menu. CQ-C1121U PUSH SEL D·M PWR CLOCK DO SRC MUTE 7 8 9 10 11 12 SQ/SCAN REP M RA Radio mode display (Default) CQ-RDP930 BAND APM 1 2 3 4 5 6 DISP N TUNE/TRACK D·M APM APM APM SEL PWR TUNE/TRACK BAND ME VOLU MUTE BAND VO L VO BAND L CQ-C1121U PUSH SEL CQ-C1121U PUSH SEL D·M Clock display PWR CLOCK DO [] or [] selects a value in the audio menu. [SEL] (Select) selects items in the audio menu. SEL PWR [DISP] (Display) exits from the audio menu. ME VOLU MUTE SRC PWR CLOCK DO SRC MUTE 7 8 9 10 11 12 SQ/SCAN REP M SRC SRC MUTE 7 8 9 10 11 12 SQ/SCAN REP M 1 2 3 4 5 6 DISP 1 2 3 4 5 6 DISP [DISP] (Display) switches the information on the display. lights while receiving the D·M (Direct Memory) station. RA N RA 1 Display the audio menu. CQ-C1121U CQ-RDP930 CQ-C1101U Note: If no operation takes place for more than 5 seconds in the audio menu (2 seconds in Main volume adjustment), the display returns to the regular mode. N lights when mute is on. Preset buttons [1] to [6] selects a preset station in the radio source, and presets the current station. (Hold down it for more than 2 seconds) [TUNE ]] [TUNE [] down/up the frequency. (Hold down it for more than 2 seconds for seek tuning. ) Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively. Preset stations can be simply called up by pressing one of the preset buttons from [1] to [6]. Press [VOL] (PUSH SEL: Select). Press [SEL] (Select). Manual station preset 2 Select a mode to be adjusted. CQ-C1121U CQ-RDP930 CQ-C1101U 3 Adjust. CQ-C1121U CQ-C1101U [] [] Power On/Off Turn your car's ignition switch to the ACC or ON position. SQ (Sound Quality) 1 Tune into a station. [. . . ] ¡ If you insert an 8 cm {3"} disc and cannot eject it, turn ACC of your car off once and turn it on again, then press [u] (Eject). ¡ Do not insert foreign matter into the disc slot. RA N Trouble Check point Trouble Check point Common Random play All the available tracks are played in a random sequence. Disc Player ¡ Start the engine. (Or turn the ignition switch to the ACC position. ) ¡ Verify the wiring. battery lead, power lead, ground lead, etc. ) ¡ Fuse blown (Contact the nearest Panasonic Servicenter. ) ¡ Ask a professional for fuse replacement. [. . . ]