User manual PANASONIC DMW-FL360LE

[. . . ] FLASH 闪光灯 DMW-FL360L Please read these instructions carefully before using this product, and save this manual for future use. Book 2 ページ ２０１２年１０月２３日　火曜日　午前９時３９分 Operating Instructions FLASH Thank you for purchasing Panasonic product. Please read these instructions carefully before using this product, and save this manual for future use. To reduce the risk of fire, electric shock or product damage, • Do not install or place this unit in a bookcase, built-in cabinet or in another confined space. [. . . ] Control panel display Choose a flash mode according to your subject and shooting conditions. € While [MANUAL] or [FP MANUAL] is selected, pressing [MODE] (3) button allows you to set the guide number. Control operation The flash light intensity is controlled automatically according to the camera’s setup. The flash will be adjusted based on the brightness taken through the camera’s lens. The flash will be adjusted based on the brightness captured by flash sensor on the flash. If the camera has communication capability, this mode can be used only when the camera is an AUTO-compatible model. In this mode, the flash is emitted according to the guide number setting. The flash displays the optimal range, which is calculated based on the guide number and camera settings. Wireless control is available with Panasonic digital cameras that support wireless mode. This mode allows you to use flash photography even at shutter speeds faster than the flash synchronization speed of the camera. ≥ Maximum output is reduced , resulting in a smaller flash working range. The flash displays the optimal range, which is calculated based on the guide number and camera settings. [ TTL AUTO] [ AUTO] Blinks: Out of flash working range [ MANUAL] [ [ RC] FP TTL AUTO] [ FP MANUAL] 10 VQT4Q07 (ENG) VQT4Q07_PP_E_GK. € Slide the lock lever to the [LOCK 1] position to latch the flash in place. € To remove the flash, slide the latch in the direction opposite to the [LOCK 1] arrow and slide it from the stand. ‰ We recommend using a single group of up to three remote flash units. ‰ Flash may not fire due to the angle or distance between the camera and the object. Book 13 ページ ２０１２年１０月２３日　火曜日　午前９時３９分 Fixing the Irradiation Angle Point the flash head at a wall or ceiling for bounce flash photography. 90º 180º 7º Pressing the bounce unlock button, turn the light-emitting section up/down and left/right. 180º Using the Wide Panel Use the built-in wide panel for flash photography when the focal length of the lens is wider than 12 mm. ≥ The ZOOM display will blink if the lens has a focal length of 12 mm or more. Using the Catch Light Plate Reflecting the flash light allows you to shoot with the catch light effect, which reflects light in the models eyes. [. . . ] ) ALL EXPRESS AND IMPLIED WARRANTIES , INCLUDING THE WARRANTY OF MERCHANTABILITY , ARE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. If a problem with this product develops during or after the warranty period, you may contact your dealer or Service Center. [. . . ]