User manual PANASONIC ER-153

[. . . ] del Valle, 03100 Tel: 54 88 10 00 Service · Assistance · Accessories Dépannage · Assistance · Accessoires Call 1-800-338-0552 (In USA) www. panasonic. com (In USA) Call 1-800-467-3405 (In Canada, only for shavers) Composer 1-800-467-3405 (Au Canada, pour les resior seulement) Model No. 1 EN, ES (U. S. A. ) Printed in Japan Imprimé au Japon Before operating this unit, please read these instructions carefully. Caution · Do not place the trimmer in locations that are subject to high humidity. [. . . ] · Clean the body only with a soft cloth slightly dampened with water or soapy water. Store the trimmer in a dry area, where it will be protected from damage. · Remove batteries from the trimmer if it is not to be used for a long period of time. Index ENGLISH ESPAÑOL Page 2 Página 22 1 2 Before use Parts Name Parts identification Inserting the batteries 1 Comb Trimmer comb attachment Trimming height display Trimming height dial ON/OFF Switch Finishing adjustment switch Hair clipper attachment Back Remove the battery cover. de Sli op en Turn the trimmer over onto its back (the side without the switch) and slide the battery cover in the direction of the arrow. Battery cover 2 Thinning plate Thinning plate lock button Match the battery poles with the direction displayed Check the direction of the batteries and insert. Two "AAA" alkaline batteries will last approximately 3 months (under the assumption that the trimmer will be used 3 times a month, for five minutes per use). Body Battery cover Body without the Trimmer comb attachment or hair clipper attachment Blade "AAA" alkaline batteries (two) Cleaning lever Body (front) Cleaning brush Body (back) Accessories Oil 3 Attach the battery cover. Hold down the cover and slide it to the left in the direction of the arrow. Battery cover 3 4 Before use Preparations before cutting Adjusting the length of the Trimmer Comb attachment 1 2 Drape a towel or cape over the shoulders. 1/4") 7mm (1/4") Sc alp Long finish (Finishing thickness of approximately 9mm) (Approx. 9mm (3/8") Finish adjustment switch 13 14 Cutting procedure Fine trimming Trimming the sideburns Without any attachments Lower the thinning plate Raise the thinning plate Thinning the bangs Make sure the switch is facing upward and move the thinning plate down the hair as if combing. Apply the cutting blade Little by little comb the trimmer through the hair approximately 2-3cm (13/16-1 3/16") from the tip of the fringe while continuously checking the result. directly Cutting around the collar, the nape of the neck, and around the ears Make sure the switch is facing upward. The mechanism of the thinning plate The thinning plate will regulate the amount of hair reaching the blade, enabling the hair to be cut in small portions. Cuts only the hairs that enter these areas. Trimming around the collar, the nape of the neck, and around the ears Align the trimmer with the line leading down from the ear Apply the blade directly to the skin. Apply the blade directly Cutting the fine hairs on the back of the neck Turn the body upside down and cut against the direction the hair lays. Apply the blade directly to the skin. Body (back) 16 Hair Skin 15 Maintenance After use Turn the switch to [0]. Attaching the blade Removing the blade Make sure the Pop-up Trimmer is in the [Down] position. 1 Insert the blade Insert the hook B into the slot A . A B Press the blade 2 Apply slight pressure from the back of the trimmer against the blade. [. . . ] Cuts only the hairs that enter these areas. Trimming around the collar, the nape of the neck, and around the ears Align the trimmer with the line leading down from the ear Apply the blade directly to the skin. Apply the blade directly Cutting the fine hairs on the back of the neck Turn the body upside down and cut against the direction the hair lays. Apply the blade directly to the skin. Body (back) 16 Hair Skin 15 Maintenance After use Turn the switch to [0]. Attaching the blade Removing the blade Make sure the Pop-up Trimmer is in the [Down] position. 1 Insert the blade Insert the hook B into the slot A . A B Press the blade 2 Apply slight pressure from the back of the trimmer against the blade. [. . . ]