User manual PANASONIC KXHNC600

[. . . ] For details about how to use the system, refer to the User’s Guide (page 26). Please read this document before using the unit and save it for future reference. A B C D Accessory item/Part number AC adaptor/PNLV2360Z Camera mounting stand/PNZB1002Z Wall mounting screws (25 mm (1 inch))/XTB4+25AVW Suspension wire tool – Safety wire: 1 PQME10080Z – Washers: 2 Small washer for attaching safety wire to camera ø12 mm (15/32 inches)/XWG26D12VW Large washer for attaching safety wire to wall ø16 mm (5/8 inches)/XWG4F16VW – Screws: 2 Small screw for attaching safety wire to camera 10 mm (3/8 inches)/XTB26+10GVW Large screw for attaching safety wire to wall 25 mm (1 inch)/XTB4+25AVW Sensor range cap/PNHG1210Z B C D E Quantity 1 1 4 1 E A 1 Other information R Design and specifications are subject to change without notice. R The illustrations in these instructions may vary slightly from the actual product. [. . . ] R Do not install the camera in areas directly exposed to water or rain. R Holes must be made in the wall for cables and wires to pass through. Panasonic takes no responsibility for issues related to opening holes in walls. R Make sure you attach the safety wire to prevent the camera from falling. ) R Mount the camera on the stable location where the unit can be adequately supported when installing. r The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected. Wall material information Siding R Use the included screws ø4 mm ´ 25 mm (ø5/32 inches ´ 1 inch). Make sure the pull-out capacity of each screw is at least 294 N (30 kgf). R If the weight of the camera is supported by the siding only, the siding could become damaged. Make sure you mount the camera in a location where the structure behind the siding can be used to support the weight of the camera. If this is not possible due to the thickness of the siding, use commercially-available screws ø4 mm ´ longer than 25 mm (ø5/32 inches ´ longer than 1 inch). R Drill a pilot hole using a drill bit that is appropriate for the type of siding. Poor example No support behind exterior surface 2 1 1 Siding 2 Open space, no support For assistance, please visit www. Com/support 17 Setup Ideal example Structure supports exterior surface 4 2 Insert the screw and tighten it. 2 2 Camera mounting stand ALC (autoclaved lightweight cellular concrete) 1 1 Siding 2 Structure behind siding Concrete R Do not use the included screws. Use screw anchors (screw ø: 4 mm (5/32 inches)) designed for concrete walls. 1 Mark the hole depth on the drill bit (1) and then drill a pilot hole. R Depending on the type of ALC panel, you may not be able to attach the camera. After consulting the manufacturer of the ALC panel, use only commercially-available metal screw anchors (screw ø: 4 mm (5/32 inches)) designed for ALC panels. R Seal the pilot hole with a commercially-available waterproof sealant. R Consult the builder or licensed professional regarding the type of anchor appropriate for the installation location and materials. [. . . ] During the “Parts” Limited Warranty period, there will be no charge for parts. You must mail-in your product prepaid during the Limited Warranty period. This Limited Warranty excludes both parts and labor for batteries, antennas, and cosmetic parts (cabinet). This Limited Warranty only applies to products purchased and serviced in the United States or Puerto Rico. [. . . ]