User manual PANASONIC KX-NT321

[. . . ] The ring tone pattern of patterns 09 to 30 is the same as pattern 01. 4 Document Version 2008-05 Features List Features List Icon Meanings (CO) = Flexible CO button = Feature number = Off-hook = Talk C. Tone = On-hook = Confirmation Tone Making Calls Calling To an extension extension no. To an outside party (CO) outside phone no. Redial REDIAL Quick Dialing quick dial no. One-touch Dialing To store PROGRAM (CO) desired no. * (max. 32 digits) AUTO DIAL PROGRAM STORE * Enter CO line access number before outside phone number. To dial assigned as a (One-touch One-touch Dialing Dialing) button Document Version 2008-05 5 Features List Personal Speed Dialing To store personal speed dial no. (2 digits) STORE System Speed Dialing To dial AUTO DIAL system speed dial no. [. . . ] Drive the 2 screws into the wall either 83 mm (3-1/4 in) or 100 mm (3-15/16 in) apart, and mount the unit on the wall. · You can find a wall mounting 83 mm template on page 19. (3-1/4 in) · Make sure that the wall that the 100 mm (3-15/16 in) unit will be attached to is strong enough to support the unit (approx. · Make sure the cables are securely Washer fastened to the wall. Drive the screw · When this unit is no longer in use, to this point. make sure to detach it from the wall. Locking the Handset Hook Pull down the handset hook until it locks to prevent the handset from falling off the handset cradle when the unit is mounted to a wall or set at a high angle. To temporarily place the handset down during a conversation, hook it over the top edge of the unit as shown. Document Version 2008-05 13 Important Information Important Information When using a KX-NT321 IP-PT, keep the following conditions in mind. · If the unit does not operate properly, disconnect the unit from the Ethernet cable and then connect again. · If you are having problems making calls, disconnect the Ethernet cable and connect a known working IP-PT. If the known working IP-PT operates properly, have the defective IP-PT repaired by an authorized Panasonic factory service center. If the known working IP-PT does not operate properly, check the PBX and the Ethernet cable. Do not clean the unit with abrasive powders or with chemical agents such as benzene or thinner. The unit must only be disassembled and repaired by qualified service technicians. · If damage to the unit exposes any internal parts, immediately disconnect the cable or cord. If the power is supplied from the network to the IP-PT [Power-over-Ethernet], disconnect the Ethernet cable. into the vents or other holes of this unit. Take special care to follow the safety suggestions listed below. Safety 1) The unit should only be connected to a power supply of the type described in the Quick Reference Guide or as shown on the label on the unit. 2) When left unused for a long period of time, the optional AC adaptor should be unplugged from the AC outlet, if you are using Power-overEthernet, disconnect the Ethernet cable. Installation Environment 1) Do not use this unit near water, for example, near a bathtub, washbowl or sink. 2) Keep the unit away from heating appliances and devices that generate electrical noise, such as fluorescent lamps, motors and televisions. It also should not be placed in rooms where the temperature is less than 5 °C (41 °F) or greater than 40 °C (104 °F). Allow 10 cm (3-15/16 in) clearance around the unit for proper ventilation. 14 Document Version 2008-05 Important Information Placement 1) Do not place heavy objects on top of this unit. 2) Care should be taken so that objects do not fall onto, and liquids are not spilled into, the unit. [. . . ] Telephone No. : 1-800-211-PANA (7262) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Document Version 2008-05 17 Important Information Customer Information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of the cabinet of this equipment is a label that contains, among other information, the following product identifier: US: ACJKXNANKX-NT321 If requested, this number must be provided to the telephone company. If trouble is experienced with this equipment KX-NT321, for repair or warranty information, please contact: Panasonic Service and Technology Company-BTS Center 415 Horizon Drive Bldg. [. . . ]