User manual PANASONIC KX-T7431

[. . . ] KX-TA624 For outside calls Set Cancel For intercom calls Set Call Waiting Receiver KX-TA1232 Set Cancel Cancel (Check the type of your Main Unit. ) To talk to the new party While hearing the Call Waiting tone Holding a current status Terminating a current status During a Conversation Holding To retrieve a call at the holding extension Holding a call To retrieve an outside call from another extension Holding a call exclusively Holding To retrieve a call on exclusive hold Screened extension no. To an extension To an external party (System programming is required. ) Transferring a call phone no. Unscreened to an extension extension no. Wait for an answer. Announce. ­4­ Features List Desired Feature Operation Useful Features To page All extensions Group group no. KX-TA624 All external speakers All extensions & external speakers Announce. KX-TA1232 All external speakers Paging Specific external speaker external speaker no. [. . . ] (Check the type of your Main Unit. ) KX-TA1232 Three-party conference To set third party's no. parameter (if required) parameter (if required) Setting Absent Message To cancel (Check the type of your Main Unit. ) KX-TA624 KX-TA1232 (Check the type of your Main Unit. ) ­5­ Features List Desired Feature Operation Useful Features KX-TA624 For Log-In For Log-Out Log-In/Log-Out KX-TA1232 For Log-In For Log-Out (Check the type of your Main Unit. ) KX-TA624 All calls extension no. Cancel (Check the type of your Main Unit. ) ­6­ Features List Desired Feature Operation Useful Features KX-TA624 # Set Cancel Do Not Disturb (DND) # KX-TA1232 Set Cancel (Check the type of your Main Unit. ) KX-TA624 (Lock code is 4 digits. ) 7 7 7 lock code lock code lock code # Lock Unlock Locking your extension 7 # KX-TA1232 (Lock code is 3 digits. ) 7 7 7 7 lock code lock code lock code Lock Unlock (Check the type of your Main Unit. ) Clearing the setting 7 7 9 9 # 0 KX-TA624 KX-TA1232 (Check the type of your Main Unit. ) * Consult your dealer for more details on the operations above. * ­7­ Location of Controls 2 RINGER 0 1 BACKLIGHT LCD (Liquid Crystal Display) 18 RINGER Volume Selector/ BACKLIGHT Illumination Selector 17 1 2 3 4 5 6 7 8 9 14 16 15 10 11 12 13 Headset Jack Microphone * The KX-T7750 does not have a microphone. * The backlit display is only available on the KX-T7431/7731/7735/7736. FWD/DND (Call Forwarding/Do Not Disturb): Used to perform Call Forwarding or Do Not Disturb. FLASH/RECALL: Used for External Feature Access or to disconnect the current call and make another call without hanging up. 7 6 AUTO ANS (Auto Answer) (Other than KX-T7750): Used to receive an incoming call in the hands-free mode. MUTE (Other than KX-T7750): Used to mute the microphone during a conversation. VOICE CALL (KX-T7750 only): Used to receive a notification via monitor in place of ringing. REDIAL: Used to redial. 5 8 ­8­ Location of Controls 9 DIALING BUTTONS WITH BACKLIGHT (KX-T7731/36): Dialing buttons are backlit when (1) you receive a call, (2) during a conversation, or (3) when BGM is activated at your phone. If this happens the telephone company will provide advance notice so you can make the necessary modifications to maintain uninterrupted service. If trouble is experienced with this equipment KX-T7731/36, for repair or warranty information, please contact Panasonic Services Company BTS Center 1225 Northbrook Parkway Suite 1-216 Suwanee GA 30024 If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. (Contact the state public utility commission, public service commission or corporation commission for information. ) This equipment is hearing aid compatible. ­ 11 ­ Exhibit J - Customer Information Data Equipment The table below shows which jacks are associated with which modes of operation: Mode of Operation Permissive Programmable Fixed Loss Loop USOC Jack KX-TA624 RJ11 RJ41S and RJ45S RJ41S KX-TA1232 RJ11 and RJ14C RJ41S and RJ45S RJ41S Systems Facility Interface Codes (FIC), Service Order Codes (SOC), USOC Jack Codes and Ringer Equivalence Numbers (REN) are shown in the table below for each port where applicable: Port CO1 ~ 3 FIC 02LS2 SOC 9. 0F KX-TA624 RJ11 USOC Jack KX-TA1232 RJ11 and RJ14C Port 0. 4B Adjuncts ­ KX and PX Devices When this adjunct is used with a leased system, permission of the owner should be requested for connection of the adjunct. KX-type telephones with message waiting lights and/or line status indicators can only be connected to host equipment and never directly to the network. KX devices can only be installed with the permission of the owner of the host equipment as "surgery" is often required on the host system. ­ 12 ­ Important Safety Instructions When using this unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. Do not use this unit near water, for example, near a bathtub, washbowl, kitchen sink, or the like. Never place the unit near radiators, or in a place where proper ventilation is not provided. Do not locate this unit where the cord will be abused by persons walking on it. 10. To reduce the risk of electric shock, do not disassemble this unit. [. . . ] Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the unit is subsequently used. 2) Perform such activities in the off peak hours, such as early morning hours or late evenings. If there is any problem, unplug the extension and connect a known working phone. [. . . ]