User manual PANASONIC RX-EX1

[. . . ] Portable Stereo CD System Operating Instructions Model No. RX-EX1 Before connecting, operating or adjusting this product, please read these instructions completely. Please keep this manual for future reference. P PC RQT5671-1P re-ex1(p01-p09)[P] 1 3/25/05, 4:22 AM Dear customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully. The model number and serial number of this product can be found on either the back or the bottom of the unit. [. . . ] The mode is also cancelled if the CD tray is opened. PLAY RE FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO Random play Plays the tracks once each in random order Press [CD PLAY MODE] before or during play to select " ". Each time the button is pressed No display (cancelled) Press [CD] to start play if in the stop mode. RANDOM To cancel Press [CD PLAY MODE] to clear " ". The mode is also cancelled if the CD tray is opened. ·Random play does not work when " " is displayed (press and hold [ PGM/ CLEAR ] first). ·Search can be done within the track in play only. 11 RQT5671 re-ex1(p10-p15)[P] 11 00. 12. 28, 4:58 PM Listening CDs Y Program play: Select up to 36 tracks to play in the order you choose Preparation: Press [ ] to switch to CD mode. Enter the track number with the numbered buttons. Listening For tracks numbered 10 and over, press [ 10] then the two digits. Repeat this step to program the tracks in the required order. Press [CD]. All the tracks are played in the selected order. The program remains intact even if play is stopped or the unit is turned off. "Cd-P" appears when play is stopped to indicate the contents are in the memory. PLAY RE FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO To cancel Press and hold [ PGM/ CLEAR ] in the stop mode until "CLEAR" is displayed. The mode is also canceled if the CD tray is opened. RANDOM "FULL" is displayed PLAY RE FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO If more than 36 tracks have been programmed. RANDOM "-- --:-- --" is displayed If the total play time of the program exceeds 100 minutes. You can still program and play tracks. To check the contents of the program While stopped Press [REW/­/ ] or [ /+/FF]. Each time one of the buttons is pressed, a track and its order in the program are displayed. Program play does not work when " " is displayed (press [CD PLAY MODE] to clear it) ( page 11). Search can be done within tracks only. 12 RQT5671 re-ex1(p10-p15)[P] 12 00. 12. 28, 4:58 PM The Radio: manual tuning Press [POWER, ] to turn the unit on. Press [TUNER BAND] to select FM or AM. Each time the button is pressed: AM FM Press [TUNE MODE] to select the manual tuning mode. Make sure that " " is not displayed. Press [REW/­/ station. " ] or [ /+/FF] to select a " is displayed during FM stereo broadcasts. Turn [­ "VOLUME#+] to adjust the volume. # FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO RANDOM Auto-tuning Press and hold [REW/­/ ] or [ /+/FF] until the frequency starts changing rapidly. Start auto-tuning again if this occurs. ) To stop auto-tuning Press [REW/­/ ] or [ /+/FF]. FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO RANDOM FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO RANDOM Using auto scan Remote control only FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO RANDOM You can search for a station by listening to all tuned-in stations for 8 seconds each. 1 s Press [TUNER] to select "FM" or "AM". To stop during the process, press [AUTO SCAN]. To improve reception Auto scan 1 PGM FM: Change the length and position of the antenna. AM: Change the facing of the unit. FADER SLEEP REC EQ ON ALL 1-REC MONO RANDOM ·AM reception is briefly interrupted if a tape deck is operated. ·To improve reception when using the unit in a building or vehicle use it near a window. FADER SLEEP EQ ON 1 PGM REC ALL 1-REC MONO RANDOM If noise is excessive in FM Remote control only FM AM Press [FM MODE/BP] to display " Monaural sound is selected (" duces when reception is weak. MONO ". " goes off) and noise re- Press [FM MODE/BP] again to cancel the mode. To receive FM broadcasts allocated in 0. 1MHz 4 7 5 8 6 9 10 1 PGM FADER SLEEP REC EQ ON ALL 1-REC ST MONO RANDOM 0 CD PLAY AUTO SCAN C-RESET FM MODE BP MODE CLOCK TIMER P TAPE TUNER CD Main unit only First press [TUNER BAND] to select "AM". The display changes in a few seconds to show the current lowest FM frequency. The minimum frequency changes and the step is changed at the same time. Repeat the above to change the step back. 13 RQT5671 re-ex1(p10-p15)[P] 13 00. 12. 28, 4:58 PM Listening The Radio: preset tuning Y Presetting radio stations Remote control only Tuning is simpler if you preset stations. ( page 13) Press [PGM/ CLEAR]. PLAY RE FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO RANDOM While " " is flashing Listening Press the numbered buttons to enter the station into a channel (1 to 12). PLAY RE FADER SLEEP EQ ON 1 PGM REC ALL 1-REC ST MONO RANDOM ·To enter channels 10, 11, and 12 Press [ 10], then the two digits. ·If " " stops flashing Press [PGM/ CLEAR] again. Selecting channels Preparation: Press [TUNER BAND] to select FM or AM. Press [TUNE MODE] to display " Press [REW/­/ channel. On the remote control ". ] or [ /+/FF] to select the Press the numbered button(s) to select the channel (1 to 12). To select channel 10, 11 or 12, press [10], then the two digits. Using preset scan You can search for a station by listening to all preset channels for 8 seconds each. [. . . ] In the U. S. A. , call 1-800-211-7262, e-mail consumerproducts@panasonic. com, or visit www. panasonic. com In Canada, call 905-624-5505 or visit www. panasonic. ca Reference pages are shown as black circled numbers Common problems "E" is displayed "UO1" is displayed "UO2" is displayed 6. Replace the batteries or use household AC power. Batteries haven't been inserted. ("UO2" appears only if you have inserted memory batteries. ) Clean the CD Wait for about an hour for condensation to clear and try again. Replace the CD if it is scratched, warped, or irregularly shaped. CD CD won't play or CD display is incorrect Ä Ä Ä Ü Cassette deck Recording not possible Poor sound quality Have the cassette's tabs been removed? [. . . ]