User manual PANASONIC S200PE2E5

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PANASONIC S200PE2E5. We hope that this PANASONIC S200PE2E5 user guide will be useful to you.


PANASONIC S200PE2E5 : Download the complete user guide (2801 Ko)

You may also download the following manuals related to this product:

   PANASONIC S200PE2E5 (856 ko)
   PANASONIC S200PE2E5 (639 ko)

Manual abstract: user guide PANASONIC S200PE2E5

Detailed instructions for use are in the User's Guide.

[. . . ] This symbol refers to a hazard or unsafe practice which can result in personal injury or product or property damage. Matters to be observed • Read these Operating Instructions carefully before using this air conditioner. If you still have any difficulties or problems, consult your dealer for help. € This air conditioner is designed to give you comfortable room conditions. [. . . ] This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning E use of the appliance in a safe way and understand the hazards involved. Do not cool or heat the room too much if babies or invalids are present. Do not turn the air conditioner on and off from the power mains switch. Do not touch the air inlet or the sharp aluminum fins of the outdoor unit. NOTICE • The compressor may occasionally stop during thunderstorms. NGLISH Important Information Regarding The Refrigerant Used This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. Refrigerant type: R410A GWP(1) value: 1975 (1) GWP = global warming potential Periodical inspections for refrigerant leaks may be required depending on European or local legislation. Indb 3 2014/09/10 9:37:56 Precautions for Use Installation This  air conditioner must be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. Before installation, check that the voltage of the electric  supply in your home or office is the same as the voltage shown on the nameplate. Operation Condition Use this air conditioner under the following temperature range. ς Indoor temperature range: Cooling mode 18°C ~ 32°C (*DBT) Heating mode 16°C ~ 30°C (*DBT)  Outdoor temperature range: Cooling mode -15°C ~ 43°C (*DBT) Heating mode -20°C ~ 15°C (*WBT) *DBT: Dry bulb temperature *WBT: Wet bulb temperature WARNING Avoid the following locations for installation. CZ-RTC3 Operation NOTE For details, refer to the Operating Instructions attached to the optional Remote Controller. High  /Medium /Low /Auto  Operation mode Select from: HEAT  Operation Mechanism  Heating performance Since this air conditioner utilizes outside air for heating,  its heating performance deteriorates as outside temperature decreases. (Due to heat pump system) →In that case, use another heating appliance. This  appliance may start defrosting operation to melt frost formed in the outdoor unit. 1Defrosting starts: The indoor unit fan stops (or the speed becomes extremely slow). ς ‘‘DRY’’ operation  Defrosting Once the room temperature reaches the level that was  set, the outdoor unit repeats the cycle of turning on and off automatically. When the outdoor unit is turned off, the indoor unit fan  will stop, too. (To prevent the humidity in the room from rising again) When the room temperature is more likely to reach the  level that was set, the fan speed is set to ‘‘breeze’’ (light wind) automatically. €‘DRY’’ operation is not possible if the outdoor  temperature is 15 °C or less. 2Heating operation resumes after several minutes: The indoor unit fan remains stopped (or it will run at a very slow speed) until the indoor heat exchanger coil warms up sufficiently. ς Should the power failure occurs while the unit is running When the unit automatically resumes operation after temporary power failure, it uses the same settings before the power was cut off. [. . . ] Cause Power failure or after power failure The operation (power) button is turned off. The air intake or air outlet of indoor and outdoor units is clogged with dust. improper temperature settings The room is exposed to direct sunlight in cooling mode. € If the breaker has been tripped, consult your dealer without turning it on. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PANASONIC S200PE2E5




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PANASONIC S200PE2E5 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.