User manual PANASONIC SA-PM53

[. . . ] Operating Instructions CD Stereo System The illustrations show SC-PM53. Model No. SC-PM53 SC-PM533 SC-PM533 is available in the U. S. A. only. Table of contents IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 18 19 20 21 22 23 SUPPLIED ACCESSORIES Please check and identify the supplied accessories. Use numbers indicated in parentheses when asking for replacement parts. [. . . ] Press [¶ REC¥8] to start recording. Note · All peripheral components and cables are sold separately. · For other recording operations, refer page 9, "Other basic operations". RQTV0097 13 English English MUSIC PORT jack ENGLISH Troubleshooting guide Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the "Customer Services Directory" on page 16 if you reside in the U. S. A. , or refer to the "Product information" on page 17 if you reside in Canada. Turn the unit off, check and correct the connections and turn the unit on (refer to page 4). You plugged the AC power supply cord in for the first time or there was a power failure recently. Consult the dealer. Sound is unfixed, reversed or comes from one speaker only. "­ ­:­ ­" appears on the display. "F61" is displayed. Listening to the radio Noise is heard. Use an outdoor antenna (refer to page 4). Turn the TV off or separate it from the unit. Separate the antenna from other cables and cords. When there is a television set nearby The picture on the TV disappears or stripes appear on the screen. If you are using an indoor antenna, change to an outdoor antenna (refer to page 4). Separate the antenna wire of the TV set from the unit. Using the cassette deck Recording is not possible. If the erasure prevention tabs have been removed, cover the holes with adhesive tape (refer to page 9). Playing discs The display is wrong or play won't start. Condensation may have formed inside the unit due to a sudden change in temperature. Replace the disc. The total number of tracks displayed differs each time the same disc is inserted. "TAKE OUT/DISC" appears on the display. The disc was incompletely formatted. Use the recording equipment to fully format the disc before recording. The unit cannot display the remaining play time for variable bit rate (VBR) tracks. (A power failure may have occurred. ) The tray will open automatically. Remove the disc from the tray, and after ensuring there is no disc in the tray, close it. The unit will make the disc changing noises for a few moments and then it should operate normally. The remote control Remote control doesn't work. Replace the batteries if they are worn. 14 RQTV0097 Specifications AMPLIFIER SECTION FTC OUTPUT POWER both channel driven simultaneously 10% Total harmonic distortion 60 Hz to 3 kHz SC-PM53 (Low channel) 40 W per channel (6 ) 38 W per channel (6 ) SC-PM533 3 kHz to 16 kHz SC-PM53 (High channel) 39 W per channel (6 ) SC-PM533 36 W per channel (6 ) Total Bi-Amp power 79 W per channel SC-PM53 74 W per channel SC-PM533 RMS OUTPUT POWER both channel driven simultaneously 10% total harmonic distortion 1 kHz SC-PM53 (Low channel) 45 W per channel (6 ) 43 W per channel (6 ) SC-PM533 8 kHz SC-PM53 (High channel) 45 W per channel (6 ) SC-PM533 42 W per channel (6 ) Total Bi-Amp power SC-PM53 90 W per channel 85 W per channel SC-PM533 Input Impedance Music port 250 mV 12 k Output Impedance Headphone 16 to 32 Phone jack Terminal Stereo, 3. 5 mm (1/8") Music port input jack Terminal Stereo, 3. 5 mm (1/8") CD SECTION Disc played [8 cm (3") or 12 cm (5")] (1) CD-Audio (CD-DA) (2) CD-R/RW (CD-DA, MP3, WMA formatted disc) (3) MP3/WMA Sampling frequency CD-DA 44. 1 kHz MP3/WMA 32 kHz, 44. 1 kHz, 48 kHz Bit rate MP3/WMA 32 kbps to 384 kbps Decoding 16/20/24 bit linear Pick up Wavelength 785 nm Beam source Semiconductor laser Laser power CLASS 1 Audio output (Disc) Number of channels 2-Channel Frequency response 20 Hz to 20 kHz (+1dB, -2 dB) Wow and flutter Below measurable limit Digital filter 8 fs D/A converter MASH (1 bit DAC) SPEAKER SECTION Type Speaker(s) Woofer Tweeter Impedance Input power (IEC) HIGH LOW Output sound pressure Crossover over frequency Frequency range Dimensions (W x H x D) Mass 2 way, 2 speaker system 10cm (4) cone type (6 ) 6 cm (23/8) cone type (6 ) 6 90 W (Max) 90 W (Max) 80 dB/W (1. 0 m) 2. 2 kHz 45 Hz to 35 kHz (-16 dB) 50 Hz to 31 kHz (-10 dB) 144 mm x 249 mm x 200 mm (511/16 x 913/16 x 77/8) 1. 9 kg (4. 2 lb. ) AC 120 V, 60 Hz 140 W 175 mm x 249 mm x 355 mm (67/8 x 913/16 x 1363/64) 5. 4 kg (11. 9 lb. ) FM TUNER SECTION Frequency range 87. 9 MHz to 107. 9 MHz (200 kHz steps) 87. 5 MHz to 108. 0 MHz (100 kHz steps) Sensitivity 0. 3 µV (IHF) S/N 26 dB 0. 2 µV Antenna terminals 75 (unbalanced) Preset station FM 15 stations AM 15 stations GENERAL Power supply Power consumption Dimensions (W x H x D) AM TUNER SECTION Frequency range 520 kHz to 1710 kHz (10 kHz steps) Sensitivity 900 µV/m S/N 20 dB (at 1000 kHz) CASSETTE DECK SECTION Track system 4-track, 2-channel Heads Record/playback Solid permalloy head Erasure Double gap ferrite head Motor DC servo motor Recording system AC bias 100 kHz Erase system AC erase 100 kHz Tape speed 4. 8 cm/s (17/8 ips) Overall frequency response (+3, ­6 dB at DECK OUT) NORMAL 35 Hz to 14 kHz S/N RATIO 54 dB (A weighted) Wow and flutter 0. 08% (WRMS) Fast-forward and rewind time Approx. 120 seconds with C-60 cassette tape Mass Operating temperature range +5°C to +35°C (+41°F to +95°F) Operating humidity range 5% to 90% RH (no condensation) Power consumption in standby mode 0. 4 W Note 1. [. . . ] · Después de cambiar el ajuste de "asignación", las frecuencias previamente preajustadas en la memoria se borrarán. Para mejorar la calidad del sonido de FM Mantenga pulsado [PLAY MODE] para visualizar "MONO". Para cancelar Pulse y mantenga pulsado [PLAY MODE] otra vez hasta que"MONO" desaparezca. · MONO también se cancelará si se cambia la frecuencia. · Deje "MONO" apagado para la escucha normal. 22 RQTV0097 Temporizador 1 Pulse [CLOCK/TIMER] repetidamente seleccionar el temporizador deseado. [. . . ]