User manual PANASONIC SC-HC49EG

[. . . ] Please read these instructions carefully before using this product, and save this manual for future use. Included Installation Instructions (l 2 and 18, 19) The installation work should be done by a qualified installation specialist. Before commencing work, carefully read these installation instructions and the operating instructions to ensure that installation is performed correctly. Book 2 ページ ２０１４年１月３１日　金曜日　午前１１時５３分 Safety precautions WARNING Unit ≥ To reduce the risk of fire, electric shock or product damage, – Do not expose this unit to rain, moisture, dripping or splashing. [. . . ] ‰ During standby, if the timer is turned on, press [DISPLAY, iPod MENU] twice to display the settings. ‰ This unit can be used as normal after the timer is set, however: – Turn the unit to standby mode before the timer start time. € Even if the audio source or the volume is changed, the timer will still use the audio source and volume that was set when the timer was turned on. * “CD”, “USB”, “FM” and “IPOD_DOCK” can be set as the music source. ‰ For timer music source through the port for iPhone/iPad/ iPod and USB devices, select “USB”. €OFF” (Cancel) (------------------J 12 ≥ The remaining time is indicated on the unit’s display except when other operations are performed. Book 13 ページ ２０１４年１月３１日　金曜日　午前１１時５３分 Changing the unit and remote control code When other Panasonic equipment responds to the supplied remote control, change the remote control code. troubleshooting Before requesting service , make the following checks. If you are uncertain about some of the check points, or if the solutions indicated in the following guide does not resolve the issue, then consult your dealer for instructions. To return all settings to the factory defaults When the following situations occur, reset the memory: 1 2 3 Press [CD/RADIO] to select “CD”. While pressing and holding [SELECTOR] on the unit, press and hold [CD/RADIO] on the remote control until the unit’s display shows “REMOTE 2”. Press and hold [OK] and [CD/RADIO] on the remote control for at least 4 seconds. ) 2 While pressing and holding down [Í/I] on the unit, reconnect the AC mains lead. ‰ To change the mode back to “REMOTE 1”, press [CD/RADIO] to select “CD” and then repeat the step 2 and 3 but replace [CD/RADIO] with [ ]. ‰ Keep holding down [Í/I] until “---------” appears on the display. Software update Occasionally, Panasonic may release updated software for this unit that may add or improve the way a feature operates. ‰ If an AC mains lead or fluorescent lights are near the cords, then keep other appliances and cords away from the cables. ˆ Checking the software version The version of the installed software is displayed. Reset the unit as follows: 1 Press [Í/I] on the unit to switch the unit to standby. ‰ If the unit does not switch to standby, press [Í/I] on the unit for approximately 10 seconds. Alternatively, disconnect the AC mains lead, wait for at least 3 minutes, then reconnect it. ‰ You may not be able to play MP3 if you have copied a multi-session disc that has no data between sessions. [. . . ] ‰ Keep the wall mount brackets out of reach of children to prevent swallowing. Screw (supplied) 3 Attach the fall prevention cord (not supplied) to this unit. cord (not supplied) Safety precautions Professional installation is required. The installation should never be done by any other than a qualified installation specialist. [. . . ]