User manual PARTNER P4546PBIO

[. . . ] 4546P BIO GB DE Operator's Manual Read the operator's manual carefully and make sure that you understand the contents before using the lawnmower. Betriebsanleitung Diese Betriebsanleitung muß sorgfältig durchgelesen werden. Stellen Sie sicher, daß Sie deren Inhalt vor Verwendung des Rasenmähers verstehen. Manuel de l'Utilisateur Lire attentivement le manuel de l'utilisateur et veiller à bien comprendre son contenu avant d'utiliser la tondeuse. [. . . ] Thoroughly clean around the fuel tank filler cap before filling, this will help to prevent dirt being introduced into the fuel system. Never fill fuel tank completely, only fill to the base of the filler neck. When filling the fuel tank from empty, or when the engine has previously run dry, a minimum of 400cc of fuel must be added (to the level of the line indicated in the diagram). Normally no further adjustment is required. 400cc Oil Use 4-stroke automotive detergent oil. Fill with oil as instructed in your Engine Owners Manual provided with your product. STARTING & STOPPING To Start your Lawnmower 1. Move the Choke control lever to the `Choke' position (K) when starting from cold, and to the `Run' position (L) when starting from hot. Pull and firmly hold the Operator Presence Control to the upper handle. Pull the starting handle gently until you feel a resistance, return the starting handle slowly. When the engine has warmed up make sure the choke control lever is in the 'Run' (L) position. To Stop your Lawnmower · Blade continues to rotate after the machine has switched off, rotating blades can cause injury. Close the fuel tap (J) CUTTING HEIGHT Adjusting the Cutting Height 1. Move the axles between the notches to achieve the desired cutting height. (M1) & (M2) USE Due to engine lubrication limitations, the mower should not be used on slopes in excess of 300. . (N) Before mowing objects such as twigs, toys and stones should be removed from the lawn. (P) Avoid running the blade over foreign objects such as stones, roots, etc. , as it may cause engine damage. Your lawnmower is fitted with an Air Cleaner, the maintenance for which is as follows:· Check the filter before each use. · Clean every 25 hrs or more frequently when used in dusty areas. Ensure that the Operator Presence Control is gripped firmly to the upper handle. Check that there is sufficient fuel in the fuel tank and the fuel tap is open 3. Check that the choke control lever is in the correct position:- 'Run' position (L) - for a hot engine, 'Choke' position (K) - for a cold engine. Once the petrol has been replaced, it may take a little time for fresh petrol to filter through. If the engine will still not start - disconnect the spark plug lead and consult you local approved Electrolux Outdoor Products Service Centre/Dealer. [. . . ] * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Blades, cables, recoil ropes, filters. Electrolux Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Electrolux Outdoor Products, or by the machine having been modified in any way. Environmental Information Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products' life. · Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling. · Awareness of the environment must be considered when disposing of `end-of-life' product. [. . . ]