User manual PEG PEREGO PRIMA PAPPA DONDOLINO

[. . . ] The exterior side of the rocker has holes on the ends for the screw heads. 2· The figure shows the correct position for the rockers on the high chair. 3· Mount the narrow part at the bottom of the rocker on the high chair as shown in the figure, pushing the long screw with the short bushing through the hole. 4· Mount the wide part at the top of the rocker on the high chair as shown in the figure, pushing the short screw with the long bushing through the hole. [. . . ] Press the red button under the tray and pull the lever, while fastening the front part of the tray (fig. To remove the tray from the high chair, follow the instructions in the reverse order. 15· Both trays can be adjusted to two different positions (1 & 2) by turning the knob under the tray counterclockwise. Make sure that the shoulder strap is correctly inserted, by pressing on it, as shown in figure A. Unfasten the safety belt from behind the backrest by pushing the buckle downwards (fig. Next, slip the safety belt buckle through the other opening in the backrest (fig. A), and fasten the buckle to the peg, pulling the safety belt until it clicks into place (fig. 20· To lift the high chair, hold it under the tray and pull upwards. 21· To lower the high chair, simultaneously press the two side buttons, stopping at the desired height. rECLINING HIGH CHAIR 22· The high chair reclines, and adjusts to four different positions: for mealtime, playtime, relaxing, or napping. To adjust it, lift the handle behind the backrest and set the high chair to the desired position. tO FOLD THE HIGH CHAIR 23· To close the tray, turn the knob under the tray counterclockwise, and pull the tray out as far as the red markers shown with the arrows in the figure. 26· Move the high chair seat to the lowest position by pressing the side buttons. To open the high chair, push the red side levers downwards, pressing on the rear frame as shown in figure 8. To remove the high chair cover, remove the safety belt from under the chair and the backrest. 30· Lower the high chair completely, and unbutton the cover from the sides of the backrest. To fold the high chair back up into its "packing position" (for transporting it or storing it in its box): - Remove the tray. Repeat the same operation, pushing the screwdriver to the left and lowering the high chair to the lowest position (the position in which it cannot be used). iNSERTING THE BATTERIES Batteries ARE NOT SUPPLIED with the high chair. ELECTRIC ROCKING-CHAIR To activate the electric rocking-chair option, you will need four MN 1400-LR14 1. [. . . ] When the rocking-chair comes to a stop, re-set it by pressing the button twice. If you wish to stop the rocking-chair before the time is up, press the same button once. dondolino may work IMPROPERLY if: · The height of the seat has not been correctly adjusted according the child's weight. The child is not fully leaning against the backrest or is moving too much; · To turn on the music, press the red button located on the control panel once (see figure). [. . . ]