User manual POLAROID ADS-1000

[. . . ] If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] Main Power Switch Side Panel Drawing Release buttons: Slide these buttons to release the portable DVD player from the Docking Station. Character indicators -9- Remote Control Preparation Refer to the drawing and remove the empty battery receptacle. Using Of Remote Control Point the remote control towards the main unit when operating. The remote control works best at a distance less than 7m and at an angle of up to 60°to the front of the unit. No obstacles may stand in the way between remote control and infrared sensor. Insert the battery into the receptacle. Make sure the polarity matches the marks inside the component. The batteries normally last for about six months. This depends on how often and for what operations the remote control is Insert the receptacle into the remote control. If the remote control unit fails to work even when it is operated near the player, replace the battery. If the remote control is not used for a long period of time, remove the battery from the compartment, to prevent damage by leakage. - 10 - Remote Control Remote Control Drawing - 11 - Remote Control 1. Or press to adjust the value of time when setting time on the display panel. One-digit number: press the number button and press the ENT button or wait 2 seconds to confirm. Two-digit number: press the first number and input the second number in 2 seconds. Three-digit number: press the first number, then input the second number in 2 seconds, and input the third number in the next 2 seconds. Use the buttons to select the editing position of hour or minute, use the buttons to adjust the value of the hour or minute upward and downward. In STANDBY mode, press this button to setup the alarm clock. - 12 - Attaching & Detaching Portable DVD player Note: Do not connect the power cord until all other connections have been made. Attaching Portable DVD player to Docking Station Follow the steps below to attach the portable DVD player to the Docking Station. It is advised to attach the rechargeable battery to the portable DVD player before this connection. Step1: Center the player on the Docking Station and line up the 4 slots on the bottom of the player with the 4 fixing hooks on the Docking Station. Step2: Press the portable DVD player down gently with two hands and the fixing hooks will fix the portable DVD player on the Docking station from moving. Detaching Portable DVD player from Docking Station Step1: Slide the two release buttons toward the front of the Docking Station to unlock the fixing hooks. Step2: Remove the portable DVD player from Docking Station. - 13 - System Connections · · Do not connect the power cord until all other connections have been made. Use the , buttons to adjust, you can adjust the items between 0 and 20. Use the , buttons to select the Language, press the , buttons to select English, French or Spanish. To restore a setting to the original value, use the buttons to select Reset, then press the ENT button to confirm the change. Press the button on the remote control to enter TV Setup menu. TV System Setup When the button is pressed, the TV system setup menu will appear: TV SETUP SIGNAL CHANNEL SKIP BLUE SCREEN FINE TUNING AUTO MEMORY PICTURE CATV 002 ON OFF EXIT - 17 - TV Function Use the buttons to select the item you want to set. [. . . ] Make sure the portable DVD player is properly connected with the Docking Station. Make sure the portable DVD player is properly connected with the Docking Station. (See page 13) Make sure the TV cable is firmly connected with the Docking Station. (See page19) Make sure the video type of the AV signal source is NTSC. [. . . ]