User manual POLAROID FLM-1514B

[. . . ] If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] After connection, turn on the power of the unit, press the INPUT button to shift to TV mode. After connecting to the antenna, turn on the unit, and go on with program searching, you can follow the below steps to select channels: 1. For 0~9 channel: Press the number buttons to select the channel X, wait two seconds and it will go to the selected channel. Or press the number buttons to input 00X, it will go to the selected channel immediately. For 10~99 channel: Press the number buttons to select channel XX, wait two seconds and it will go to the selected channel. For 100~125 channels: Press the number buttons to select channels XXX, and it will go to the selected channel. Note: This item is only available in Component and VGA modes. Audio Setting Press the MENU button once to enter the setup menu. Press the button to select Audio and press the OK button to enter the menu shown on the right. In the Audio setup menu, press the button to select the desired item and press the OK button to enter. Press the MENU button to return to the previous menu. Volume Setup Press the button to select Volume and press the button to adjust the level. Bass Setup Press the button to select Bass and press the button to adjust the level. Press the MENU button to return to the previous menu. - 16 - TV Function Treble Setup Press the button to select Treble and press the button to adjust the level. Balance Setup Press the button to select Balance and press the button to adjust the level. Press the MENU button to return to the previous menu. MTS Setup Press the button to select MTS and press the OK button to enter. Press the button to select the desired item and then press the OK button to confirm your selection. Press the MENU button to return to the previous menu. Sleep Setting Press the MENU button to enter the setup menu. Press the button to select Sleep and press the OK button to enter the menu shown on the right. In the Sleep setup menu, press the button to select 15Min, 30Min, 45Min, 60Min, 75Min, 90Min, 105Min, 120Min or Off. Press the MENU button to return to the previous menu. - 17 - TV Function Parental Setting Note: The Parental Function is the same as that of V-CHIP. Press the MENU button to enter the setup menu. Press the button to select Parental and press the OK button to enter the menu shown on the right. In the Parental setup menu, press the OK button and then use the number buttons to enter the pin. Then press the OK button to continue and display the menu as shown on the right. Change PIN Press the button to select Change PIN and press the OK button to enter. Use the number buttons to enter the new pin you want and then press the OK button to confirm. Then use the number buttons to enter the new pin again and press the OK button to confirm and return to the previous menu. - 18 - TV Function Clear All Press the button to select Clear All and press the OK button to enter. [. . . ] Check if the connections with the external AV signal source are correct. Check if the video type input signal is not corresponding to the unit. Make sure there are no obstructions between the remote control and the player. Make sure batteries are not weak. There is no sound. LCD does not display a picture. There is no picture or picture moves up and down. The remote control does not work. Note about External Interference: Static or other external interfere may cause the player to behave abnormally. [. . . ]