User manual POLAROID ID 4 INSTANT ID SYSTEM

[. . . ] Feed the plug and long cord out through one of the doors near the bottom of the cover. 4 Place the laminator on the base: slide the bottom of the laminator into its slot on the base (5), then lower it into position. 5 Wrap the laminator cord around the bottom of the laminator several times (6), then plug it into its outlet (7-F). 6 Plug the power cord into its socket (7-G), and then into an appropriate electrical outlet. [. . . ] The slot in the center tab should engage a centering pin inside the holder. Test this by moving the plate from side to side; if it is inserted correctly, it should move only slightly. Fit the bottom of the plate into the holder so the bar pushes in the flat metal spring (21). Gently push in and downward until the plate snaps into place, under the upper lip of the spring and behind the two retainers. To remove the plate, push in on the flat metal spring with your fingertip or the eraser-end of a pencil (22). Load the film 1 Be sure that the film holder is in the UP (or LEFT) position, then open the door. Before loading the film, check that the developer rollers are clean (see Clean the developer rollers). 3 Check that the white tabs are not caught between the pack and the holder (24). 4 Close and latch the door, with the end of the black tab sticking out (25-S). The "Pull film tabs" indicator will light up. Page 2 5 Pull the black tab straight, all the way out of the holder (26). If not, see No white tab? Diecut the print 1 Insert the print into the diecutter as shown (38). 3 Release the handle, then remove the scrap paper from the diecutter (40). Laminate the picture Most ID pictures will be sealed inside a plastic pouch for protection. Then pouches may be printed with additional information, or have a magnetic stripe or other security features. 2 Place the pouch inside the carrier, with the sealed side of the pouch against the closed side of the carrier (42). The rollers inside the laminator will start, and pull the carrier through. The carrier will come out through the slot in the back of the laminator. 4 Allow the carrier to cool for several seconds before removing it from the laminator exit slot (44). If the edges of the ID card pouch appear ragged, the laminator thermostat may be set too high. If the pouch is not completely sealed, the thermostat may be set too low. To adjust the laminator thermostat: 1 Turn off the laminator and disconnect the power cord. 2 Insert a screwdriver into the opening and turn the control toward (+) to increase the temperature, or toward (-) to decrease it (46). [. . . ] only) This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer' instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Subpart J or part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient the receiving antenna. [. . . ]