User manual POLAROID MACRO 5 SLR

[. . . ] The knob clicks into position at each magnification; the camera will not function if the knob is between lens settings. In addition to the magnification, the selector shows the camera-to-subject distance and icons that represent the approximate area of a subject included in the picture. dirt or bits of dried developer on the rollers can cause a pattern of repeated spots or bars on pictures. Clean both rollers with a soft, lint-free cloth, dampened with water if necessary (3). [. . . ] English Focusing and framing the subject 1 Hold the camera at the approximate distance From the subject for the selected magnification. With some subjects, you may want to make the picture lighter or darker to enhance specific details. Press the light arrow to lighten pictures Ranging lights on the subject (10). Move the camera nearer or farther from the subject, until the two lights merge (11). Press the dark arrow to darken pictures Press the opposite arrow until green light aligns directly over the vertical line (return to nominal position). The camera has a memory and saves your custom Lighten/Darken settings. 4 The viewfinder shows the area included in the Picture, with the ranging lights in the center of the picture. If you have difficulty seeing the ranging lights, check that the camera is at the correct distance from the subject. The two built-in electronic flash units are designed to provide even illumination at all reproduction scales. Take the picture Outdoor use Look through the viewfinder, and reframe the subject as needed. If you have difficulty seeing the ranging lights: Magnification, and is at the correct distance from the subject. Move the ranging lights to a lighter area on Look over the top of the camera, rather than through the viewfinder. Camera does not function The flash and/or LED ranging lights will not function if the film pack battery is weak or dead. no image in viewfinder The magnification selector knob is between settings. Pictures too light The camera may be too close to the subject for the selected magnification. Polaroid Corporation certifies that this product conforms to the following standards: Safety: Low Voltage Directive 73/23/EEC EMC: EN55022, Class B; EN50082-1; IEC 801-2, 801-3 If you need assistance or additional information please contact a Polaroid dealer, or office nearest you. 2 This device must accept any interference Received, including interference that may cause undesired operation. Only) Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Your Macro 3 camera has been thoroughly tested and inspected before shipment. All parts are guaranteed against defects in materials and workmanship for one full year from the date of original purchase. [. . . ]