User manual POLAROID MINIPORTRAIT 402B

[. . . ] 2 Place your subject approximately 40 inches (1 meter) in front of the camera. Adjust the camera so that the lights converge on the subject's chin. [. . . ] To turn the face Brightener off before you take the picture, press the Boost button again. After you press the button, the Pull Film light comes on in the LED display, or if the camera is set to take another picture on this film, it shows Ready. Note: If nothing happens when you press the Shutter Button, the Aiming Lights probably went out. When this happens, press the Aiming button and take the picture again ­ before the Aiming Lights go out. 8 You can lighten or darken your picture by adjusting the aperture lever and/or the flash exposure setting (in the LED display). To lighten the picture, move the aperture switch to the left; or increase the flash exposure from the LED display. Should this product or any component or accessory included with it, except software, prove to be defective at any time during the warranty period, Polaroid Corporation will, at its discretion, either replace or repair this item, without charge. This warranty does not cover damage caused by accident, incorrect installation, unauthorized modification, and misuse or abuse. This warranty excludes all consequential damages and does not affect your statutory rights. Some jurisdictions do not allow the limitation or exclusion of consequential damages, so the foregoing may not apply to you. Radio interference United States This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with this instruction manual, may cause harmful interference to radio communications. [. . . ] This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with this instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, which must be corrected at the user's expense. [. . . ]