User manual POLAROID POLAVIEW SUPERPORTABLE 10

[. . . ] Polaview SuperPortable 10 FCC Statement Warning: This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with limits for a Class "A" computing device pursuant to Subpart B of Part 15 of the FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference in which case the user, at his own expense, will be required to take whatever measures may be necessary to correct the interference. Warning: Changes or modifications to this unit not expressly approved by Polaroid could void the user's authority to operate the equipment. Canadian Notice This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A prescrites dans le Règlement sur le brouillage radioélectrique edicté par le ministère des Communications du Canada. European Notice Warning: This is a Class A product. [. . . ] The REPLACE LAMP indicator lights when the LAMP HOURS value reaches zero. Press it again to turn the projector and lamp off. REPLACE LAMP POWER Using the projector 23 The remote control Use the RC-8 remote control to change all the control panel and on-screen control functions. Whenever you press a remote-control key, the LED on the remote control blinks rapidly. The remote-control keys share the same functions as the corresponding keys on the projector control panel. To use the remote control, point it at the front of the projector and press a key, or bounce the infrared (IR) signal off the projection screen. Note: When the operating distance between the projector and remote control becomes too short for your purposes, install a fresh battery as described in the Changing the remote-control battery section in Chapter 4, Maintenance. The RC-8 remote control a b c d e f g h i j a SOURCE b LED indicator c Arrow keys (alignment) d BRIGHT (BRIGHTNESS) e MENU f F2 g RESET h LAMP (REPLACE LAMP) i CONTRAST j VOLUME 24 Using the projector Menu-mode on-screen controls The Menu-mode on-screen controls let you adjust the projected image and enhance the appearance of your presentation. The function of each on-screen control is described below. INVERSE To use the INVERSE function, press and release MENU, then press either the v or w key to scroll through the menu until you display INVERSE. Press either the or key to switch between positive and negative images. A graphic appears on the screen to indicate the current INVERSE setting. To use the WIDTH function, press and release MENU, then press either the v or w key to scroll through the menu until you display WIDTH. A graphic appears on the screen to indicate the current relative value of the WIDTH setting. WIDTH may affect the FOCUS control; refer to the Troubleshooting guide in Chapter 5 for more information. To use the FOCUS function, press and release MENU, then press either the v or w key to scroll through the menu until you display FOCUS. Press either the or key to select from 8 possible image-phase-adjustment settings. The WIDTH control may affect FOCUS; refer to the Troubleshooting guide in Chapter 5 for more information. To use the MIRROR function, press and release MENU, then press either the v or w key to scroll through the menu until you display MIRROR. Press either the or key to switch from the standard to the mirror (reverse) image. A graphic appears on screen to indicate the current MIRROR setting. WIDTH FOCUS MIRROR Using the projector 25 PALETTE To use the PALETTE function, press and release MENU, then press either the v or w key to scroll through the menu until you display PALETTE. Press either the or key to switch from one of two color modes: 8-color or 16, 194, 277color. To use the TINT function, press and release MENU, then press either the v or w key to scroll through the menu until you display TINT. A graphic appears on screen to indicate the current relative value of the TINT setting. To use the TONE function, press and release MENU, then press either the v or w key to scroll through the menu until you display TONE. A graphic appears on screen to indicate the current relative value of the TONE setting. [. . . ] Camera Services 24-26 Anzac Avenue Auckland Tel. : (09) 377 3773 Norge Polaroid (Norge) A/S Industriveien 8B, 1473 Skårer Postboks 80, 1471 Skårer Tlf: 67 90 47 10 Fax: 67 90 51 73 Österreich Polaroid Ges. m. b. H. Eitnergasse 5A 1231 Wien Tel. : 869 86 27 Fax: 869 81 00 Portugal Polaroid (España) S. A. Sucursal em Portugal Edificio Monumental Avenida Praia da Vitória, 71-A 4º B 1050 Lisboa Tel. : (01) 316. 10. Ponce de León 701 Miramar, Santurce 00907 Tel. : (809) 725-6240 Fax: (809) 725-5462 Schweiz/Suisse/Svizzera Polaroid AG Hardturmstrasse 133 8037 Zürich Tel. : (01) 277. 72. 72 Suomi Polaroid Oy Sinikalliontie 10 02630 Espoo Puh: 90-502 35 33 Fax: 90-502 35 50 Sverige Polaroid AB Ekholmsvägen 34 Box 204 127 24 Skärholmen Tel. : 08-710 08 50 Fax: 08-740 73 68 U. K. [. . . ]