User manual POWERFIX KH 2902 MULTI-PURPOSE METAL DETECTOR

[. . . ] Read these operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. Pass this booklet on to whoever might acquire the appliance at a future date. [. . . ] Should a battery ever be swallowed, IMMEDIATELY seek medical assistance. Metal and power cable detection Locating of: Power cables, metals Power supply: 9V Block battery (not included) Maximum detection depth for metal pipes: 40 mm Maximum detection depth for copper pipes: 20 mm Maximum depth for power cables: 80 mm Take the Multi-Purpose Metal Detector from its packaging. Lay the tape for removal of the battery underneath the 9V block battery and press it into the battery compartment 5. Before using the appliance for this task, first test it by locating a pipeline or electrical power cable at a known position. To enable a power cable to be detected by the appliance, its circuit must be under power. If you wish to trace for example the cable route from light switch to lamp, switch the lamp on. Place the function switch 3 into the position METAL for locating metals and into the position VOLTAGE for locating power cables. Press the detector with the measuring head 2 vertically against the wall to be examined, then hold the button PUSH 4 down (the red LED 1 glows weakly). Should there be a metal object / a power cable close to the measuring head 2, the red LED 1 glows more brightly and several signal tones sound one after the other. In this case, release the button PUSH 4 and then press it again, to reactivate the detection process. [. . . ] The purpose of this obligation is to ensure that batteries are disposed of in a non-polluting manner. Lämna in den till ett företag som har tillstånd att ta hand om kasserade apparater av den här typen eller till rätt återvinningsstation på din kommuns avfallsanläggning. [. . . ]