User manual POWERFIX KH 3236 MULTI-DETECTOR

[. . . ] No liabity will be accepted for damage caused by manipulation of the laser equipment, as well as of the ultrasound transmitter/receiver, or through disregard of these safety instructions. Optimal and safe working with the multi-detector is only possible if you read these operating and safety instructions completely and strictly follow their instructions. Do not use the appliance at locations where there is a risk of fire or explosion, e. This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. [. . . ] For this, use the spirit level: The bubble in the glass 8 must stand between the marking lines (see Fig. When you hold the button READ 6 pressed down and slowly move the appliance over the surface to be measured, the appliance continually measures the distances. Take note of the following illustrations: The further you are from the wall, the wider is the area (a) that the MultiMeasurement Detector must measure by ultrasound (Fig. Therefore take care that the Manifold Measurer is always directed at a right angle towards a level surface (Fig. Ensure that there are no objects positioned within the measurement area. In the display 2, , , +" appears and the distance measured carries itself over to the lower line. The new measurement is added to the old measurement in the lower line. In the upper line the measured length appears and , , W" (Width) starts to flash. The measured width appears on the upper line and the result of the area calculation in the lower line. Both measurements are added together and the result is shown in the lower line. In the upper line the measured length appears and , , W" (Width) starts to flash. In the upper line the measured width appears and , , H" (Height) starts to flash. Both measurements are added together and the result is shown in the lower line. Before using the appliance for this task, first test it by locating a pipeline or electrical power cable at a known position. The locating of concealed objects is the same in all three modes (STUD = wood, AC WIRE = live electric power cables, METAL = metal). Place it flat against the wall where you wish to search for concealed objects. As the arrows in the display move closer to the centre of the display, you are getting closer to the concealed object. When the arrows touch and a constant signal tone is heard, mark this position (see Fig. Now repeat the procedure, but this time approach the object from the other side. Proceed with the search for wood objects as described in the section , , Locating concealed objects". [. . . ] The purpose of this obligation is to ensure that batteries can be disposed of in an environmentally friendly manner. Mätpunkt Display Materialväljare (STUD/AC WIRE/METAL) Knapp MODE Knapp till fäststift Knapp READ (Avläs) Knapp M (Minne) Vattenpass Laseröppning Ultraljudssändare/-mottagare Funktionsväljare (LASER/DETECTOR/DISTANCE) Knapp RM (Read Memory) Knapp till fäststift Knapp +/= Batterifack Knapp PUSH Upprepa steg 2 till 4 för att lägga till fler mätvärden. Upprepa steg 2 till 7 för att lägga till fler mätvärden. Upprepa steg 2 till 7 för att lägga till fler mätvärden. [. . . ]