User manual POWERFIX KH 3236

[. . . ] The following conditions can contribute to inaccurate results: ­ very thick walls ­ weak battery ­ deeply laid power cables or pipework ­ shielded cables ­ thick walls with thin pipes or power cables ­ walls panelled with metal sheets ­ very moist conditions · This appliance is not suitable for detecting power cables in circuits, ­ which are isolated from the mains power supply. With this appliance pipework made of plastic or similar materials cannot be detected, only pipework made of metal. If you do not intend to use the appliance for an extended period, remove the batteries. Should the batteries leak, wear protective gloves and clean the battery compartment with a dry cloth. [. . . ] In the display 2, , , +" appears and the distance measured carries itself over to the lower line. The new measurement is added to the old measurement in the lower line. In the upper line the measured length appears and , , W" (Width) starts to flash. The measured width appears on the upper line and the result of the area calculation in the lower line. Both measurements are added together and the result is shown in the lower line. In the upper line the measured length appears and , , W" (Width) starts to flash. In the upper line the measured width appears and , , H" (Height) starts to flash. Both measurements are added together and the result is shown in the lower line. Before using the appliance for this task, first test it by locating a pipeline or electrical power cable at a known position. ⷠIn cases of doubt, always ask a qualified building contractor. The locating of concealed objects is the same in all three modes (STUD = wood, AC WIRE = live electric power cables, METAL = metal). Place it flat against the wall where you wish to search for concealed objects. As the arrows in the display move closer to the centre of the display, you are getting closer to the concealed object. When the arrows touch and a constant signal tone is heard, mark this position (see Fig. Now repeat the procedure, but this time approach the object from the other side. Proceed with the search for wood objects as described in the section , , Locating concealed objects". To be sure that the object is wood, slide the material switch 3 to METAL. Should the Multi-Measurement Detector not find anything, then the object is wood. [. . . ] The warranty for this appliance is for 3 years from the date of purchase. The appliance has been manufactured with care and meticulously examined before delivery. In the event of a warranty claim, please make contact by telephone with our Service Department. The warranty covers only claims for material and manufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. [. . . ]