User manual POWERFIX PBMP 30 A1

[. . . ] In addition, pass these documents on, together with the product, to any future owner. Safety instructions To avoid the risk of accidents and damage to the appliance: • Operate the pump ONLY when it is secured by the supplied mounting against jolting, twisting and canting. € Check the pump for a faultfree condition before ever taking it into use. [. . . ] µ Securely tighten the cross-head screw on the mounting y so that the drill u is being firmly held. 2012 12:08 Uhr Seite 36 µ Now push the pump q onto the mounting y so that the drive shaft e µ µ projects into the thread of the drive shaft w, and the pins of the mounting y are located in the reception holes on the pump q. Let the drill u start to run in a clockwise rotation and at low revolutions and then guide the pump q straight onto the drive shaft e. Attach the suction hose to the connection o and the pressure hose to the connection a. µ Insert the electric drill u, with the pre-assembled drive shaft r in the chuck, into the mounting y. µ Tighten the cross-headed screw on the mounting y firmly, so that the drill u µ Now push the pump q onto the mounting y so that the drive shaft r µ µ projects into the thread of the drive shaft w and the pins of the mounting y are located in the reception holes on the pump q. Allow the electric drill u to run with a clockwise rotation and low revolutions and guide the pump q straight on to the drive shaft r. Attach the suction hose to the connection o and the pressure hose to the connection a. 2012 12:08 Uhr Seite 37 Disassembly of the drive shaft Disassembly of the short drive shaft e Wheel rim chuck µ Open the chuck with the chuck key through the recess i and then remove the pump q from the mounting y. µ Unscrew the short drive shaft e by using a cross-headed screwdriver and the open-ended spanner from the pump q. µ Using the open-ended spanner through the recess i, counter screw the µ Allow the electric drill u to run with an anti-clockwise rotation and low reµ Remove the pump q from the mounting y. Quick-release chuck Disassembly of the long drive shaft r Chuck with SDS fitting µ Using the open-ended spanner through the recess, i counter screw the drive shaft w of the pump q. µ Allow the electric drill u to run with an anti-clockwise rotation and low revolutions. If the pump q does not start to suck up within 12 seconds, turn the drill u off immediately to avoid seizure. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. The warranty period will not be extended by repairs made under warranty. [. . . ]