User manual PRECISION POWER PRO15
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PRECISION POWER PRO15. We hope that this PRECISION POWER PRO15 user guide will be useful to you.
Manual abstract: user guide PRECISION POWER PRO15
Detailed instructions for use are in the User's Guide.
[. . . ] CAUTION: Do not connect this terminal directly to the vehicle battery ground terminal or any other factory ground points.
5. RCA input jacks
These RCA input jacks are for use with source units that have RCA outputs. A source unit with a minimum level of 200mV is required for proper operation. [. . . ] A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system.
6. High level inputs
The high level inputs are for use with speaker level wiring. Some source units do not have RCA outputs, so use this terminal for speaker level signal input. CAUTION: Never use high level input when RCA inputs available.
CONTROL FUNCTIONS 7. REMOTE
Connect the remote controller to control the subwoofer amplifier volume from the driver seat location, for ease of adjustment during playing.
8. LEVEL Control
The level control will match the amplifiers sensitivity to the source units signal voltage. Low Pass Filter Control
This control is used to select the desired low pass x-over frequency. Select cable and fuse according to the following table.
MODEL CABLE FUSE
S2000. 1D 2-4# 200A
S1300. 1D 4# 120A
S850. 1D 4-6# 80A
PRO15 4-6# 60A
2. Connect the amplifiers ground cable to a close, bare metal part of the frame or chassis. Connect the remote terminal to remote output of the head unit using 16 gauge (or heavier) wire. Connect the fuse holder within 18"(45cm) of the car battery, and run the selected cable from this fuse to the amplifier. If using a subwoofer for 2-CH and 4-CH, bridge the channels by using the Left "+" and the Right "-" terminals.
WIRING DIAGRAM
Fig 3. Mono amplifier wiring (1 woofer load)
RCA signal
Source Unit
REMOTE signal
FUSE
Fig 4. Mono amplifier wiring (High level input mode)
A RC
l na sig
Source Unit
FUSE
ON/OFF control signal
WIRING DIAGRAM
Fig 5. Mono amplifier wiring (multi woofers)
RCA signal
Source Unit
REMOTE signal
*Equivalent parallel woofer load cannot be less than the minimum load rating. [. . . ] Mono amplifier wiring (High level input mode)
A RC
l na sig
Source Unit
FUSE
ON/OFF control signal
WIRING DIAGRAM
Fig 5. Mono amplifier wiring (multi woofers)
RCA signal
Source Unit
REMOTE signal
*Equivalent parallel woofer load cannot be less than the minimum load rating. The 2 negative terminals are paralleled inside the amplifiers, as are the 2 positive terminals. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PRECISION POWER PRO15
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PRECISION POWER PRO15 will begin.