User manual PROEL ADIS5

[. . . ] Water and moisture: This apparatus should not be used near water (i. e. bathtub, kitchen sink, swimming pools, etc. ) Ventilation: This apparatus should be placed in a position that doesn't interfere with correct ventilation. This unit, for example, should not be placed on a bed, sofa cover o similar surfaces that could cover ventilation openings, or placed in a built-in installation, such a bookcase or a cabinet that could block air flow trough ventilation openings. Heat: This apparatus should be placed away from heat sources, like radiators, heat registers, stoves or other products (including amplifiers) that produce heat. [. . . ] The power cord must be unplugged by the wall outlet, and all the connections wires should be disconnected as well. Don't open this unit: Don't attempt to open or to repair this unit by yourself. For any problem solution not described in this owner's manual, please refer to qualified personnel only or consult us or your National Distributor. Damages requiring services: · Don't attempt to do operations not described in this user's manual. · In the following cases please refer to an authorized maintenance center or skilled personnel: - When the unit works improperly or it doesn't work at all. - The unit doesn't operate normally o it exhibits a marked change in performance. Maintenance: The user shouldn't attempt maintenance operation not described in this user's manual. Every maintenance operation should be done by qualified personnel only. IMPORTANT SAFETY INSTRUCTIONS: · Install this unit following owner's manual instructions. · Don't install, connect or disconnect power supply when the unit is powered, otherwise there's an high risk of electric shock. · Don't open the unit, there are no user serviceable parts inside. · If you detect a particular smell from the unit, please immediately turn it off and disconnect the AC power cord. · Don't force commands (switches, controls, etc. ) · · · · To obtain good speakers wire contacts, please tighten the screw terminals firmly. This unit should be placed in a rack (see INSTALLATION) and kept far from: Wet places Direct exposure to heat sources (like sun light) Non properly ventilated places Disconnect the power cord during storms or when the unit is not used. In order to prevent fire and electric shock risks, it's necessary to keep the unit far from sprinkling and drops. Please don't put cups, vases or other object containing liquids over the unit. In case of interferences from source signal, THD value will raise over 10%. Don't place this unit in a bookshelf o in other places with small room. is not responsible for any damage that occurs due to a wrong unit installation. · · · Thank you for choosing one of Proel products, and for your confidence towards our brand, synonymous of professionalism, accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in professional installation systems. 1. DESCRIPTION This unit has been specifically designed for audio line distribution for P. A. [. . . ] With this selector (fig. 1 ref. 3) in MONO position, the unit distributes CH1 signal only to 10 outputs (5 CH1 section outputs plus 5 CH2 section outputs) while the signal present in CH2 input will not be routed to any output. Use the selector (fig. 1 ref. 3) to choose the mono/stereo operational mode (see Installation point 3). If peak indicator LED is continuously lit, it means that its input signal is too high. In order to obtain a non distorted signal, please lower the sound source output level until LED turns on only during music peaks. e. [. . . ]