User manual PROEL FLASH15HA

[. . . ] ­ This product should be site away from heat sources such as radiators, lamps and any other device that generate heat. ­ This product should be located so that its location or position does not interfere with its proper ventilation and heating dissipation. ­ Care should be taken so that objects and liquids do not go inside the product. ­ The product should be connected to a power supply mains line only of the type described on the operating instructions or as marked on the product. [. . . ] Then avoid the use of inadequate supports, we suggest to use PROEL stands and accessories only. In case of the speakers are provided of rigging points: DO NOT SUSPEND THE SPEAKERS FROM THE HANDLES, use exclusively these rigging points. Consult professional rigger or structural engineers prior to suspending loudspeakers from a structure not intended for that use. Always know the working load limit of the structure supporting the loudspeakers. Always make sure that the rigging hardware minimum rating is at least five times the actual load, speakers and rigging hardware. In case of suspended installations of active loudspeakers where is not possible to turn on and off the speakers from their appropriate switches, we recomend to install switches on the mains lines, for this purpose consult an expert electrician for the exact dimensioning of wiring. Locate the speakers as far away as possible from radio or television receivers or other sensitive equipment. These speakers have a strong magnetic field which can induce hum and noise into unshielded devices that are located nearby with consequent deterioration of reception of image and sound. Reserves the right to change these specifications at any time without notice. Declines any liability for damages to objects or persons caused by lacks of maintenance, improper use, installation not performed with safety precautions and at the state of the art. Check periodically that the slots for its proper ventilation and heating dissipation are not obstructed by dust, remove the dust using a dry brush or a compressed air gun. The amplified loudspeakers of Proel have been designed with CLASS I construction and must be connected always to a mains socket outlet with a proctetive earth connection (the third grounding prong). Before connecting the product to the mains outlet make certain that the mains line voltage matches that shown on the rear of the product, a tolerance of up to ±10% is acceptable. Inside the amplified loudspeakers are present special safety devices such as: Fuse on rear panel. Inside the passive loudspeakers are present special safety devices such as: Protection against excessive power applied at HF-driver speaker. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] 7 inches) FLASH15HA 2-way vented enclosure with directivity controlled horn 45 Hz - 20 KHz 99 dBspl @ 1 W / 1 m * Rated consumption is measured with pink noise with a crest factor of 12 dB, this can be considered a standard music program. Adjustable speaker pole for speaker-subwoofer separation with terminal pieces Ø 35 mm. Professional aluminium floor-stand for speaker with terminal pieces Ø 35mm. Supplied with a screw locking system, a steel safety pin and "Aircushioned" air-damped release device to grant a flexible, fast and easy adjustment. [. . . ]