User manual PROGRESS EDITION30

[. . . ] The mains circuit for the socket used must be protected with a fuse with a rating of at least 10 A. Never remove the mains plug from the socket by pulling on the cable. Do not use the appliance if: - the cable is damaged. Avoid running over the mains lead with the appliance or the vacuum brush. [. . . ] Always ensure that a paper filter as well as a MICROFILTER and a HEPA filter are inserted. Toner dust from laser printers and copiers must not be vacuumed using normal household vacuum cleaners. This is a domestic vacuum cleaner and should only be used to vacuum dry dust. The manufacturer is not liable for any damage caused by incorrect use or operation. Do not vacuum matches, glowing ashes or cigarette ends using the appliance. Avoid picking up hard, pointed objects as these may damage the appliance or the paper filter. Do not expose the appliance to the effects of the weather, humidity or sources of heat. Should the mains lead be defective, the complete cable roller must be replaced by PROGRESS customer service or an authorised repair centre. Repairs to electrical appliances may only be carried out by qualified specialists. Bags full of normal household dust may be disposed of with household waste. Motor protection filter The motor protection filter is a permanent filter and does not have to be replaced regularly. See What to do if . 12 Cleaning As required, wipe the housing and the paper filter compartment with a damp cloth. Occasionally vacuum the floor nozzle and brushheads with the crevice nozzle. The appliance can be switched on again after approximately 30 minutes. the fuse has blown The fuse may blow if you use other electrical appliances with high power consumption on the same electric circuit at the same time as the vacuum cleaner is in use. This can be avoided if you set the electronic power adjuster to the lowest power level and then select a higher level after switching the appliance on. Your vacuum cleaner can be fitted with a gentle startup control which reduces the starting current to the motor and therefore prevents the electric circuit cut-out being triggered under normal conditions. It is possible that there will be a delay of about 4 seconds in the appliance starting up on the lowest power level. Paper filter Progress P60 Carrying and Storage To make the appliance easier to store and carry, slide the floor nozzle into the tool rail. Parking System For storing the suction pipe and nozzle during short pauses in vacuuming. The bracket on the nozzle is slid into the parking rail on the appliance. . . . [. . . ] It is possible that there will be a delay of about 4 seconds in the appliance starting up on the lowest power level. Paper filter Progress P60 Carrying and Storage To make the appliance easier to store and carry, slide the floor nozzle into the tool rail. Parking System For storing the suction pipe and nozzle during short pauses in vacuuming. The bracket on the nozzle is slid into the parking rail on the appliance. . . . the paper filter is damaged at some point and the motor protection filter becomes dirty Remove motor protection filter, clean (shake out) and replace. [. . . ]