User manual PROGRESS MAX 2000

[. . . ] Equipment packaging: The cardboard packaging can be deposited at a waste paper recycling point. deposit the recyclable polyethylene (PE) bag at a PE recycling point. [. . . ] Press the release button and pull out the connector in order to remove the suction hose. Press the foot button; the cable rewinds automatically when vacuuming has been completed. Adjust the Telescopic Tube (depending on model) Using the floor nozzle* For the daily care of carpets and hard floors. Without being changed over manually, the floor nozzle is entirely suited for daily vacuuming of carpets and hard floor surfaces such as parquet, tiles, linoleum, etc. Using the floor nozzle* For the daily care of carpets and hard floors. Switching on and off You can switch the appliance on and off by pressing the On/Off button. Crevice and upholstery nozzle stored in the appliance For specific cleaning requirements, two additional parts are included with the vacuum cleaner in an integrated accessories compartment*. Power adjustment - Rotary control* The suction power can be varied to suit individual vacuuming requirements using the electronic power adjuster. Power adjuster Secondary air regulator* Using the regulator on the handle, you can reduce the suction power, e. The wider you open the regulator, the lower the suction power at the nozzle becomes Prior to maintenance or cleaning, ensure that the appliance is switched off and that the mains plug has been removed from the socket: Insert the new paper filter as far as it will go in the guide rails; only then can the lid be closed. Changing the microfilter We recommend replacing the microfilter at each fifth paper filter replacement, and at the latest when there is a clean dust bag and the dust level indicator is completely red with the nozzle raised. Changing the paper filter The paper filter must be replaced if the window on the filter replacement indicator is completely red when the appliance is operating at maximum power and the nozzle is raised from the floor. [. . . ] The paper filter is damaged at some point and the motor protection filter becomes dirty Remove motor protection filter, clean (shake out) and replace. It is difficult to push the nozzle Reduce the power setting on the appliance. [. . . ]