User manual PROGRESS PC4101

[. . . ] PC4100 PC4101 PC4102 PC4103 PC4105 4602 02 03 03 *depends on the model modell-abhänging suivant le modcle depende del modelo depende do modelo a seconda del modello hangt van het model af modelltl függen w zalenoci od wersji zavisno od modela v závislosti od verzie zálezí na provedení English PROGRESS PC 4100, 4101, 4102, 4103, 4105 DESCRIPTION 1. Suction inlet Dustbag full indicator Variable power control On/off switch Cable rewind button Wheel Dustbag compartment Carrying handle Compartment open button Hose 11. [. . . ] Do not operate the vacuum cleaner too close to heaters and radiators, stoves etc. Before you start using the vacuum cleaner, please remove large or sharp objects from the floor to prevent damage to the cloth dustbag. INSTRUCTIONS FORUSE Before placing into operation make certain that the filters are in the proper position. Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. It is advisable to set the power control to MIN before switching on the appliance. To rewind the power cable, press the rewind button with foot, and guide the cable with hand to ensure that it does not whip causing damage. By moving the variable power control, the suction power can be adjusted. -4- - 29 - PROGRESS PC 4100, 4101, 4102, 4103, 4105 MAINTENANCE REPLACING THE DUSTBAG Always operate the cleaner with the dustbag installed. If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not close completely. Dustbag reference number: Menalux T218, BT218, CP218 TEXTILE DUST BAG (PC 4101, 4102, 4103) Remove the textile bag from the holder (fig. Replace the plastic clip ensuring that both sides of the bag are parallel (fig. 23). REPLACING THE FILTERS The dustbag must be replaced if the window of the dustbag full indicator is completely red when the cleaner is operating at maximum power and the nozzle is raised from the floor. Filters should be replaced at least twice a year or when they become visibly soiled. Always operate the cleaner with filters installed to avoid reduced suction. [. . . ] Blocked air flow and dirty filters: The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt. Disconnect from mains and allow the cleaner to cool for 20-30 minutes. [. . . ]