User manual PROGRESS PI1530X

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Select and start a washing programme 65 66 67 68 68 69 70 71 72 73 75 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Never lift or lower the basket on one side only When the basket is in the higher position you will not be able to use the cup racks. After loading your machine always close the door, as an open door can be a hazard. Using no more than the correct amount of detergent contributes to reducing pollution. Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Use of combi detergent tablets These products are detergents with a combined cleaning, rinsing and salt functions. They can also contain other different agents depending on which kind of tablets you choose ('3 in 1', '4 in 1', '5 in 1' etc. The refilling of the salt container and the rinse aid dispenser are no longer necessary. In this case the rinse aid indicator light will always remain on when the machine is switched on. If you decide to turn back to the use of standard detergent system we advise that you: 1. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (2). Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Turn the knob until the desired programme symbol corresponds with On/ Off indicator light on the control panel. The programme starts automatically and the start/cancel indicator light comes on. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and al- Cleaning the filters The filters must be checked and cleaned from time to time. Turn the handle about 1/4 a turn anticlockwise and remove the filter system Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). Remove the flat filter from the base of the washing compartment and clean both faces thoroughly. Put the flat filter back in the base of the washing compartment and ensure that it fits perfectly under the two guides (C). Put the filter combination in place and lock by turning the handle clockwise to the stop. [. . . ] If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. A water inlet hose with safety valve must only be replaced by the Service Force Centre. Water drain connection The end of the drain hose can be connected in the following ways: 1. [. . . ]