User manual PROGRESS PV3550

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Multi-tab function Select and start a washing programme 70 71 72 73 73 75 75 76 77 79 80 81 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] After loading your machine always close the door, as an open door can be a hazard. please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Using no more than the correct amount of detergent contributes to reducing pollution. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (2). Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. This appliance is equipped with the "Multitab function", that allows the use of the "Multitab" combi detergent tablets. These products are detergents with a combined cleaning, rinsing and salt functions. Adjust the water hardness setting according to the hardness of the water in your area. After having selected the washing programme, press the delay start button until the indicator light corresponding to the chosen hours flashes (3h, 6h or 9h). Close the door; the countdown will continue from the point at which it was interrupted. Close the door; the programme will start from the point at which it was interrupted. cancel a delay start or a washing programme in progress · Simultaneously press and hold the two function buttons B and C until all the programme lights come on. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. ­ The indicator light of the programme just ended remains on. The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. ⷠWater may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Programme Degree of soil Type of load Programme description Prewash Crockery, cut- Main wash up to 70°C lery, pots and 2 intermediate rinses pans Final rinse Drying Prewash Crockery, cut- Main wash up to 65°C lery, pots and 1 intermediate rinse pans Final rinse Drying Crockery and cutlery Main wash up to 65°C Final rinse Prewash Main wash up to 50°C 1 intermediate rinse Final rinse Drying Main wash up to 45°C 1 intermediate rinse Final rinse Drying This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and al- Cleaning the filters The filters must be checked and cleaned from time to time. [. . . ] If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. A water inlet hose with safety valve must only be replaced by the Service Force Centre. Water drain connection The end of the drain hose can be connected in the following ways: 1. [. . . ]