User manual PYRAMID PR530A

[. . . ] Using any kind of thinner, alcohol or volatile liquid will mar the surface, cause blotching on the exterior and erase the markings and should therefore be avoided. Dripping warning: The product shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the product. Power plug When disconnecting the power cord from the power outlet, always take hold of the plug, and not the wire, and pull free. Never connect or disconnect the power plug with wet hands since you may receive an electric shock. [. . . ] TUNER This switch is pressed when you wish to listen to the radio broadcasts from the tuner connected to the TUNER terminals. PHONO This switch is pressed when you wish to listen to records on the turntable connected to the PHONO terminals. When the power of the unit is turned on the initial position of input selector switch is set to "TUNER". TONE CONTROL TREBLE VOLUME The treble sound is emphasized when the TREBLE knob is rotated clockwise from its "0" position while it is attenuated when the knob is rotated counterclockwise. TONE CONTROL BASS VOLUME The bass sound is emphasized when the BASS knob is rotated clockwise from its "0" position while it is attenuated when the knob is rotated counterclockwise. Adjust the volume so that it does not hurt your ears when using the headphones. - If you do not intend to use your headphones, always ensure that you unplug them. REMOTE STANDBY INDICATOR The Power Amplifier is in remote standby state if the remote standby indicator is lighted. MUTE Press this switch to mute the sound, press it again to cancel the mute function. VOLUME LEVEL DISPLAY Press this switch to see the volume level indicated by INDICATOR DISPLAY. 4 OPERATING PROCEDURES Before starting operation Check that the controls have been set to the following positions before commencing operation Rotate the VOLUME control counterclockwise as far as it will go and set it at the "0" minimum volume position. Set the BASS and TREBLE tone controls to the "0" (center) position. If you find a remote standby indicator is lighted, the power amplifier is in remote standby mode. (a) Press the power switch off and press it once again after the remote standby indicator is off. After switching on, the indicator will be shinning on "Phono" for a second, after that the unit is set to "Tuner". Playing a program source 1. Press the desired input selector switch to select the program source to which you wish to listen. To listen to a component connected to VIDEO terminals: Press the VIDEO switch. To listen to a component connected to AUX terminals: Press the AUX switch. 3. Gradually turn the VOLUME control clockwise until the desired volume level is obtained. [. . . ] (P. S: This key only works with our CD of our HI-FI system. ) REMOTE CONTROL UNIT Remote controlling instructions The remote control box can directly control majority of system functions of HI-FI SYSTEM. The functions include power control of the whole system, Volume control, sound field control, CD operation control, Tuner operation control and also source control function. This remote controller may not function properly if an obstacle is located between it and the receiving unit, or if the remote controller is held at an improper angle with respect to the receiving unit. Battery Installation Remove the rear cover of the remote controller by sliding it backward. [. . . ]