User manual REMINGTON 710

[. . . ] To Adjust The Rear Sight: WARNING: Always check the chamber and the magazine to make sure there are no cartridges in the firearm. The rear sight elevation screw is located ahead of the rear sight aperture. The ventilated rib is screwed to the barrel and is isolated through the use of synthetic buffers, both above and below the rib. In this way the barrel moves independently of the rib ensuring accuracy. [. . . ] The safety mechanism provides protection against accidental or unintentional discharge under normal usage when properly engaged and in good working PICTURE 3 order. The safety mechanism is not a substitute for following the rules of safe gun handling. To engage the safety mechanism, pull the safety mechanism fully to the rear towards the `S' position. See Picture 3. "S" POSITION Always put the safety mechanism in the `S' position before handling, loading or unloading the firearm. PICTURE 4 When you are ready to fire the firearm, push the safety mechanism forward towards the `F' position to disengage the safety mechanism. Your fingers and all other objects should be kept outside of the trigger guard and away from the trigger until you are actually ready to fire by pulling the trigger. Never pull the trigger when the safety mechanism is in the `S' position. "F" POSITION WARNING!The firearm will fire when the trigger is pulled and the safety mechanism is in the `F' position. Even when the safety mechanism is in the `S' position, careless handling can cause the firearm to fire. SEE THE TEN COMMANDMENTS OF FIREARM SAFETY ON PAGE 2. The Security System The firearm you have purchased is equipped with an integrated security system which is new to this product. This security system enables the owner to secure the bolt assembly on the firearm in the action open position with the use of a special key. "J" SLOT PICTURE 5 SECURITY BUTTON 7 THIS SECURITY SYSTEM DOES NOT ELIMINATE THE NEED FOR SAFE GUN HANDLING AND STORAGE, INCLUDING KEEPING THIS AND EVERY GUN UNLOADED AND LOCKED IN A SECURE PLACE WHEN NOT IN USE. READ AND FOLLOW THESE AND OTHER SAFETY RULES IN THIS INSTRUCTION BOOK. If you lose the keys DO NOT attempt to disengage the security system using a foreign object. Even if you think the security system is engaged, careless handling can cause the firearm to fire. BOLT STOP (UP) To Install Bolt Assembly: The bolt assembly locks the cartridge into the chamber. Rotate the bolt stop counter-clockwise to the vertical position (Model 710 only). See Picture 8. 8 PICTURE 8 BOLT STOP (DOWN) PICTURE 9 4. Rotate the bolt stop clockwise until it snaps into place (horizontal) (Model 710TM only). To place the bolt assembly in closed position, push the bolt handle down. Rotate bolt stop counter-clockwise to vertical position (Model 710 only). Slide the bolt assembly from the firearm. PICTURE 10 LUGS BOLT STOP RELEASE The Trigger Assembly The trigger is adjusted at the factory. All adjustments to the trigger assembly and firing mechanism must be made by the factory or a REMINGTON® RECOMMENDED GUNSMITH. NEVER remove the trigger mechanism or make adjustments to the trigger or trigger assembly. [. . . ] Part descriptions can be found on the parts listing page in this manual. Box and Street Address) including zip code, telephone number and e-mail address. · Method of payment: Mastercard, Visa, Amex or Discover card number and expiration date. Owner's manuals/instruction books may be requested via our web site at: www. remington. com or by calling 1-800-243-9700. [. . . ]