User manual REMINGTON GCT-2000

[. . . ] S Except when charging, always unplug this appliance from the electrical outlet immediately after using. To reduce the risk of burns, fire, electric shock or injury to persons: s This appliance is for household use only. S Do not use this appliance with a damaged or broken cutter unit, as injury may occur. To disconnect, turn all controls to OFF, then remove adapter from outlet, then detach power cord from the clipper for storage. [. . . ] S Roll the Zoom Wheel toward the top of the clipper to adjust for longer length, and toward the bottom of the clipper for shorter length. As you become familiar with the settings, you can then select your desired length setting. Trimmer Guard Attachment NOTE: Trimmer guard must be attached to the clipper in order to use the hair length selector. Remove trimmer guard attachment if you are defining hairline edges such as sideburns, trimming the nape of your neck, trimming your beard line on front of neck, or if you want to clean the cutter assembly. S While holding clipper in one hand and holding the Zoom Wheel to prevent it from turning, gently pull the trimmer guard attachment away from the clipper. S While holding the clipper in one hand, and holding the Zoom Wheel to prevent it from turning, slide the guard over the top of the clipper until it clicks into position. NOTE: The trimmer guard attachment can only be placed on the clipper one way; if it does not fit properly, remove and reverse it. Allow the clipper to cut through the hair without moving it too quickly. Use short strokes when cutting, and initially use the longest setting. To cut the hair at the top of the head, hold the hair between your fingers and cut a small amount at a time. To trim around the ears and short hairs at the nape of the neck you must remove the trimming guard. Angle the clipper and lightly stroke around each ear to the back of the neck. The final trim can be made with the hair clipper or the included scissors. For styled hair or giving quick trims, you may prefer using your hair clipper without the trimming guide. Holding the clipper as shown, lightly stroke upward making sure you are taking off the desired amount of hair. When completed, comb the area to remove any loose hair and to determine whether you need any further cutting. Make sure the length of the hair is trimmed to the same length on both sides of the head. Using a shorter setting (#1 or #2), hold the comb flat against the head and move the hair clipper from the back of the neck to the crown of the head. Determine the length you want the beard to remain, and choose the corresponding setting. 5mm (#1) guide will give you the shortest beard while the 14mm (#8) or 18mm (#9) will give you the longest. If you want a longer beard you can use the barber's comb as a trimming guide. Start trimming under your chin and work toward your ear and beard line. [. . . ] This warranty does not cover products damaged by the following: s Accident, misuse, abuse or alteration of it s Servicing by unauthorized persons s Use with unauthorized accessories s Connecting it to incorrect current and voltage s Any other conditions beyond our control No responsibility, obligations, or liability is assumed for the installation or maintenance of this product. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations and exclusions may not apply to you. Residents: To order accessories, contact us at 800-736-4648, visit us at www. [. . . ]