User manual REMINGTON HC5200

[. . . ] € Connect the charging adaptor to the product and then to the mains. € If the product is not going to be used for an extended period time (2 – 3 months), unplug it from the mains and store. € This appliance should be charged by approved safety isolating adaptors PA-3215E (for EU version) or PA-3215U (for UK version) with the output capacity of 3. , CORDED USE • Connect the charging adaptor to the product then to the mains. [. . . ] Then change the setting to 9mm and continue to cut the top of the head. , STEP 4 – Top of the head • Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on top of the head against the direction in which the hair normally grows. € For longer hair on top, use the longer length comb attachment (24 – 42mm) to achieve the desired style. , STEP 5 – The finishing touches • Use the clipper without an attachment comb for close trimming around the base and sides of the neck. € To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed clipper at right angles to the head, tips of the blades lightly touching the skin and then work downwards. AE 5 HR SL GR RO TR RU HUN PL CZ SK P FIN S DK I E F NL D ENGLISH , SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS • Starting with the longest guide comb attached (24 - 42mm), cut from the back of the neck to the crown. Hold the guide comb flat against the head and slowly move the clipper through the hair. € Use the same procedure from the lower side to the upper side of the head. Then cut the hair against the direction in which it grows and level with the sides. € To give a “flat top” look, the hair on top of the head must be cut over the top of a flat comb. € Use a closer guide comb to taper the hair down to the neckline as desired. c CARE FOR YOUR HAIRCLIPPER Your clipper is fitted with high quality blades. To ensure long lasting performance of your clipper, clean the blades and unit regularly. , AFTER EACH USE • Ensure the clipper is switched off and disconnected from the mains before cleaning. , EVERY SIX MONTHS • At regular intervals the blade set should be removed and cleaned. It is not necessary to remove the small moving blade from the unit. € If the moving blade has been removed this can be re-fitted by slotting the coated blade holder over the pin in the centre of the interior product head. The groove on the coated blade, just below the teeth, rests on a metal plate at the opposite side to the screw holes. The fixed blade is fitted with the raised profile pointing outwards and fixed with the 2 screws. [. . . ] AE 7 HR SL GR To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled. DANSK Tak for at have købt dit nye produkt fra Remington®. , INSTRUKTIONER FOR KLIPNING • For en jævn klipning gives kammen/klingen mulighed for at klippe sig hele vejen igennem håret. For længere hår på toppen bruges kammen til længere længder (24 – 42 mm) for at opnå det ønskede look. [. . . ]