User manual REMINGTON MB-70

[. . . ] Close supervision is necessary when this trimmer is used by, on, or near children or invalids. Use this trimmer only for its intended use as described in this manual. S Comb hairs outward so they are at their maximum height and facing in the same direction. S For first-time use, or if the trimmer has not been used for a long period of time, you will need to charge the batteries for 14-16 hours to enjoy the full capacity of cordless operation. [. . . ] (MB-100 only) The MB-100 may be used with the cord plugged in or unplugged. Plugging in the adapter cord will not provide power to the trimmer, but only recharge the batteries. Dual-blade system Dual-blade system enables you to quickly change from a standard-width blade for full grooming to a narrow-width blade for detail trimming around a mustache or goatee, defining the beard line and clipping any stray single whiskers that may have been missed. With the trimming guide attachment removed, depress the head rotation button to rotate and position the desired blade over vacuum intake port. NOTE: Trimmer guard must be attached to the trimmer in order to use the hair length selector. The hair length selector and trimmer guard attachment ensures precise trimming and has nine adjustable positions: Setting 1 2 3 4 5 6 7 8 9 Beard Style Stubble look Short Medium Length 1. S Before you begin, comb your hair in the direction that it grows so that the hairs are at their maximum height and facing in the same direction. S Determine how much hair you want to cut and position the hair length selector accordingly. Remember, until you are familiar with using the trimmer, it's always better to select a longer hair setting initially in order not to trim too much hair. S Use the unit's styling comb or another small comb to comb and hold the beard hairs in place while trimming. S Holding the trimmer horizontally with the cutting unit facing away from you, move the trimmer along the length of the comb. S Turn the trimmer so the front of the cutting unit is facing away from you. S Start trimming under your chin and, following your jawbone line, work toward your ear and upper beard line using an upward motion. Allow the trimmer guard attachment to follow the contours of your face. You may trim either against or with the direction of beard growth, whichever you prefer. S Hold trimmer horizontally with the cutting unit facing either up or down. S Trim hairs using an upward or downward motion, against or with the direction of hair growth, whichever you prefer. S For an even closer "stubble look, " remove the trimmer guard attachment and repeat the previous two steps. Be careful not to remove too much hair, creating a "blotchy" look. S You will need a hand mirror for this operation if performing it alone. The mirror is not necessary if trimming is performed by a second person. S Use your fingers to lift the hair at the base of you head up off the neck. [. . . ] S Remove the front panel below the Zoom Wheel by prying off with a small screwdriver. S Using a small Phillips head screwdriver remove 3 screws, 1 above the power inlet and 2 at the top location. S Remove 6 screws holding the motor bracket to the housing, 4 on the top side and 2 at the lower fan position. Do not burn or mutilate, as they may burst or release toxic materials. [. . . ]