User manual REMINGTON MSC-100

[. . . ] Slide the battery cover out in the direction indicated by the arrow and pivot battery cover up as shown. Insert batteries to correspond with the positive (+) and negative (-) terminals as shown inside the battery compartment. After each shave, turn the shaver off and remove the head assembly by gripping both sides of the head assembly and pulling up. [. . . ] Always keep the swiveling protective cover over the head assembly to protect the delicate twin screens. CAUTION: Do not remove or replace the head assembly while the shaver is running, as it may cause damage to the screens or cutters. to avoid possible damage to the cutters , it is not recommended to remove the cutter assem bly. If however the cutter assembly pops off during the cleaning process, it may be easily remounted. Take care not to lose the small spring that is seated on each oscillator tip. to remount the cutters , turn the cutter assembly so the shape of the hole in the base of the assembly is properly aligned with the shape of the oscillator tip. Place the cutters back into posi tion and press down gently on the center of the cutter. NOTE: Replacement screens and cutters are NOT available for this shaver. On average, screens will have a useful life of anywhere from 5 to 9 months before wear is visible, (depending upon usage). Inspect screens before each use and if there is any visible wear or other damage to the screens, discard the shaver - DO NOT USE. Remington warrants that your product, except as noted below, is, on date of purchase, free from defect in material and workmanship. Remington will correct any such defect without charge if you return the complete product either in person or by mail, postage paid, to a Remington company-owned Service Center or Authorized Service Dealer within 60 days after the date of purchase with original receipt. Do not return this product to the retailer from whom the product was purchased. This warranty does not cover damage by accident, misuse, abuse, or by affixing an unauthorized accessory or alteration to the product, or by connection of the product to any but the specific current and voltage indicated in an accompanying instruction booklet, or by any other conditions beyond our control. In addition, this warranty does not cover the flexible screen assembly or cutters on our foil type shavers. No responsibility, obligation, or liability is assumed for the installation or maintenance of this product. [. . . ] Service under the Remington warranty can be obtained outside the United States by Remington-authorized Distributors and Service Dealers. Please consult your local telephone directory for the nearest location. Always replace defective or dead batteries and dispose of carefully in accordance with local and/or state laws. [. . . ]