User manual REMINGTON R-1000

[. . . ] 30039_R-1000_IB_tri 8/24/06 2:54 PM Page 1 ® POWERCLEAN TITANIUM Shaving System TM Use and Care Guide R-1000 30039_R-1000_IB_tri 8/24/06 2:54 PM Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. Read all instructions before using this appliance. WARNING To reduce the risk of burns, fire, electric shock or injury to persons: This appliance is for household use only. Close supervision is necessary when this appliance is used by, on, or near children or invalids. An appliance should never be left unattended when it's plugged in except when charging. [. . . ] Fill with fresh solution, insert new filter and replace upper portion. Wipe off the unit periodically with a damp cloth and remove any hair debris that has collected where the shaver sits. Preparing the System Cleaning solution: 1. Press the latch buttons on the sides of the cleaning base and lift 1 the upper portion off the unit. You will need to keep the buttons pressed in as you move the upper portion away from the base. Pour the bottle of 3 cleaning solution into the base of the unit through the opening where the filter was removed. The filter collects hair clippings and debris, and should be replaced along with the solution. Failure to do so will permanently clog the system rendering it inoperable. Replace the top portion of the cleaning base by lining up the three posts with the three holes in the tank. Push the top portion down until the two latches click into place. Charging Prior to using your shaver for the first time, put it on charge for 24 hours. NOTE: It may take up to 3 cycles for the battery to reach full capacity. Using Cleaning Base Plug the power cord into the cleaning base and then into an electrical outlet. Place the shaver into the unit, head side down, and slide its "tail" toward the "neck" of the base until it stops. Charging Your shaver automatically begins to recharge as soon as it is in place in the cleaning base. While it is charging, the blue indicator light will flash; when it is fully charged the blue light will stop blinking and glow steadily. Your Shaver can also be recharged by plugging it into the cord directly. Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. Operating the Cleaning System Cleaning To activate cleaning mode, simply press the CLEAN button on the cleaning base. The amber indicator light flashes through the entire cleaning cycle, which lasts approximately 2 minutes. When the cleaning cycle has been completed, the amber light will stop blinking and glow steadily. The unit then returns to charging mode. 8 9 30039_R-1000_IB_tri 8/24/06 2:55 PM Page 10 How To Use NOTE: To avoid damage to the cleaning system, use only Remington's special cleaning solution. residents: To order, contact us at (800) 231-8793, www. remington-products. com, or visit your local retailer. [. . . ] CAUTION: DO NOT PUT IN FIRE OR MUTILATE YOUR BATTERIES WHEN DISPOSING AS THEY MAY BURST OR RELEASE TOXIC MATERIALS. DISPOSE PROPERLY IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS. Performance Guarantee Full Two-Year Warranty Spectrum Brands, Inc. warrants this product against any defects that are due to faulty material or workmanship for a two-year period from the original date of consumer purchase. This warranty does not include damage to the product resulting from accident or misuse. [. . . ]