User manual REMINGTON R-15 VTR

[. . . ] Use this appliance only for its intended use as is described in this manual. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water. If any of these things happen, return the appliance to an authorized service center for examination and repair. Never operate the appliance with the air openings blocked or while on a soft surface, such as a bed or couch, where the air openings may be blocked. [. . . ] NOTE: If your shaver battery is completely discharged or the shaver has not been used for a long time, the shaver may not start when operated using the cord. If this happens, charge the shaver for approximately five minutes before shaving. NOTE: It may take up to 3 cycles for the battery to reach full capacity. Wait until the cleaning cycle has finished before removing the shaver from the base. If the shaver is removed during the cleaning cycle it will be covered with cleaning solution and be unusable. Shaver should be left in cleaning base for 24 hours to allow it to dry for next usage. When the solution levels get low, the red replacement indicator light will begin to flash. This means you have enough cleaning solution left for approximately 5 more cleanings. If the red light stops blinking and glows steadily, the unit will not operate until the solution and filter have been replaced. Replacing the Filter and Solution Only Remington's special cleaning solution and filter can be used with the Power Clean System. The cleaning solution contains a high percentage of alcohol and a special oil that lubricates your shaver each time it is cleaned. Before cleaning, detach the handheld unit from the power supply cord before cleaning. The cutting system of this shaver was designed to be cleaned by rinsing under warm running water or by brushing. Open the hair pocket by pressing the release button and rotating away from the body of the shaver. You may blow out the stubble thoroughly, or rinse the shaver head in water. At Least Once a Week: For more complete cleaning, remove the cutter retainer assembly from the hair pocket by turning the center knob approximately 1/4 turn counter clockwise. Hold cutter retainer assembly as shown, and remove head by turning approximately 1/8 turn in the direction shown. Reassemble head to cutter retainer assembly by aligning and turning head 1/8 turn in the opposite direction. Clean each head and cutter set one at a time to prevent mixing cutter components. After cleaning, place cutter retainer assembly in the hair pocket, and secure by turning center knob approximately 1/4 turn clockwise. Do not use any aggressive cleansing agent as this may destroy the shaver coatings. To clean and lubricate your shaver's cutters and head assembly, apply Remington® Shaver Saver® (SP-4) Lubricant. [. . . ] Open the head assembly by pressing the head release button and lifting the head assembly. Remove the trimmer assembly by squeezing 4 the sides as shown in the picture. Using a small Phillips head screwdriver, remove the 3 screws from the back of the shaver. Cut the wires on both ends of each battery and remove them from the shaver. [. . . ]