User manual REMINGTON R-970

[. . . ] S Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. S Do not use an extension cord or a voltage converter with this appliance. S Do not use this appliance with a damaged or broken cutter or head, as facial injury may occur. (A) (A) Head & cutter assembly (B) On/off button (C) Locking bar (D) Low-battery indicator (red) shows when shaver needs charging (R-960/970 only) (E) Green charging indicator (F) Trimmer button (G) Storage pouch (H) Plastic head guard (I) Cleaning brush Congratulations on your purchase of a premium Remington® shaver. [. . . ] This allows the shaver to work the way it was designed for the closest shave and minimum wear. Avoid holding the shaver at an angle so only one head touches the skin. This encourages your whiskers to stand out, making it easier for them to enter the cutting chamber. Pressing only flattens your whiskers, which makes it harder for them to enter the cutting chamber. To trim To use the Easy-View ® pop-up trimmer, simply push the trimmer but ton up. To conserve battery energy (on rechargeable shavers only), it is recommended to use the trimmer only when needed for trimming. When through using, push the trimmer button downward to lock into the OFF position. Trim sideburns Simply touch the edge of the trimmer to the desired line for neat, clean sideburns. Trim mustache Hold shaver at desired trim line for a quick, easy, professional trim. The R-950/960/970 have a corded operation feature that allows you to run the shaver directly off the cord in cases when batteries are low. Simply connect the cord to the shaver and then to an electrical outlet. Note: Your shaver will not recharge during corded operation, so after shaving, turn the shaver off and leave it plugged in so it can be recharged. Always keep the protective head guard on the shaver head and keep the trimmer in the OFF position when the shaver is not in use. Remington ® Pre-Shave Powder Stick (SP5) or the Pre-Shave Lotion with Aloe (SP-6) can help maximize your shaver's performance. Both absorb moisture and facial oils, helping set up the hairs so they enter the cutting chamber more easily. Grip the head assembly by the three ridges and pull it off the shaver. Use the cleaning brush to sweep out the internal part of the head assembly and the hair pocket area, where 3 shaver spindles are located. Open the shaver head and unscrew the center screw knob to remove the cutter retainer assembly. It is very important to replace your heads and cutters when necessary to ensure a close, comfortable shave without irritation. Here are some signs of head and cutter wear, indicating that replacement is needed. Irritation As the heads get excessively worn you may experience some skin irritation. This would be especially noticeable when you apply after-shave lotion. [. . . ] This warranty gives you specific legal rights, and you may also have other rights that vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations and exclusions may not apply to you. Canadian residents: To order shaver accessories, please call 800-268-6531 or visit us at www. The following procedures should be followed for battery remo val: S Make sure your shaver is unplugged from any outlets, so you don't risk an electrical shock. [. . . ]