User manual REMINGTON WR-5000

[. . . ] Do not use while bathing or in the shower if it is plugged in. Do not store it in temperatures exceeding 140°F (60°C). To disconnect, turn all controls to OFF, then remove plug from outlet. Never drop or insert any object into any of the appliance's openings. [. . . ] Using Shaver with Soap or Foam Lather When using soap or foam lather, the shaver will glide smoothly over the skin, cleaning away oil residue while at the same time leaving skin soft and smooth. Do not use skin lotion, nourishing cream, or shaving cream of the non-lathering type. Caution: Not recommended use on head, underarms or any other parts of the body. & Canadian residents: To order, contact us at 800-231-8793, visit us at www. remington-products. com or visit your local retailer. Cleaning and Maintenance To assure smooth, efficient performance, it is important to clean your shaver. Daily Brush inside the head assembly after each use: 1. Grip the head assembly by the three ridges and pull it off the shaver. Use the cleaning brush to sweep out the internal part of the head assembly and the hair pocket area, where 3 shaver spindles are located. Replace head assembly. Replace head assembly on the shaver simply by pushing it onto the shaver. When removing the headguard or placing it back onto the shaver, do not apply pressure to floating cutter surfaces, as you may damage them. Cutter retainer assembly Center screw knob Locating holes Head/frame assembly Floating cutter heads Locating pins Weekly Clean under the cutter assembly at least once a week: 1. Unscrew the center screw knob 1/4 of a turn to remove the cutter retainer assembly. Use the cleaning brush to sweep the dust and hairs from under the cutters. Never clean the shaver or replace the cutters while it is plugged into an electrical outlet. Do not clean or remove the head assembly while the shaver is running or plugged in, as it may cause damage to the unit's heads or cutters. Replace worn or damaged parts with Remington® replacement parts only. Important: Make sure to align the two locating holes in the Cutter Retainer assembly with the pins in the Head Frame Assembly. [. . . ] This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to province. Some states do not allow the exclusion or limitation of incidental, special or consequential damages. 120 VAC, 60 Hz REMINGTON and SMOOTH & SILKY are trademarks of ROVCAL, INC. [. . . ]