User manual REMINGTON XR 1390

[. . . ] A replacement can be obtained via our International Service Centres. 2 ENGLISH D 4 13 3 6 2 C KEY FEATURES 1 2 3 4 5 6 7 8 On/off switch Head and Cutter assembly Individual flexing heads Hairpocket LED display Detail trimmer Trimmer release button Charging pins 9 10 11 12 13 14 Charging stand Adaptor (not shown) Head guard (not shown) Cleaning brush (not shown) Grooming styler head Adjustable comb for grooming styler head (not shown) AE 3 UA HR SL GR RO TR RU HUN PL 5 8 CZ SK 1 P FIN 5 9 S 7 DK I E F NL GB ENGLISH C GETTING STARTED It is recommended that you use your new shaver daily for up to four weeks to allow time for your beard and skin to become accustomed to the new shaving system. , CHARGING STAND • Rotate open the charge stand fully to stand firmly on a flat surface while charging. [. . . ] , • • • • • • • 4 CHARGING YOUR SHAVER Ensure the appliance is turned off. When charge is low ‘Lo’ will appear on the screen and will flash until the shaver is plugged in to charge. When fully charged the minutes remaining will show ‘60’ minutes To preserve the life of your batteries, let them run out every 6 months then recharge for 24 hours. eNGLISH • The adaptor automatically adjusts to a mains voltage between 100V and 240V. € This appliance should be charged by approved safety isolating adaptors PA-0510E(K) with the output capacity of 5. F INSTRUCTIONS FOR USE , , • • • • • , • , • , • • • • SHAVING Note: This shaver is for cordless use only. Only apply light pressure on the shaving head while shaving (pressing too hard can damage the heads and make them vulnerable to breakage). SHAVING WITH SHAVING GEL Follow the same instructions as dry shaving if using shaving gel. CAUTION After use with shaving gel, please rinse the head and cutters under warm water to clean away any excess gel and debris. Hair clippings can also be washed out of the hair pocket and or shave face by rinsing these under the tap. CLEANING TRIMMER Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil. Uk/ parts-accessories CLEANING GROOMING HEAD The easiest and most hygienic way to clean the grooming head is by rinsing the head after use with warm water. A cleaning brush can also be used to remove cut hair from the blades. BATTERY REMOVAL • • • • • • • • • • The battery must be removed from the appliance before it is scrapped. The appliance must be disconnected from the supply mains when removing the battery. Using a small screwdriver, pry the ‘collar’ off of the top of the handle. Using a small screw driver, pry up the newly unsecured inner housing to expose the battery. To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled. [. . . ] Using a small screw driver, pry up the newly unsecured inner housing to expose the battery. To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled. 34 DANSK Tak for at have købt dit nye produkt fra Remington®. [. . . ]