User manual ROSE DISPLAYS ANOMULTI SQUARE WITH CABLE CLIP AND BALL CHAIN

[. . . ] AnoMultiTM Instruction Sheet Parts AnoMulti 12AM300SQ Cable Clips 06-5050 End Caps 06-5545 Ball Chains 96-0302P Instructions for Hanging Step 1 Insert the poster into the Slim Holder by either sliding the poster into the holder or tapping the holder onto the poster. 1 Note: For thinner substrates, it may be necessary to staple the edge of the graphic before inserting into Slim Holder. Step 2 Slide Slim holder into AnoMulti holder. 2 Figure 1 Figure 2 Step 3 Insert single ball of ball chain into inner channel of Cable Clip. [. . . ] Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 4 Note: Be sure to slide the ball chain into place by pushing on the cable clip. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Note: For OneUp applications, the AnoMulti Holder is conveniently marked in the center. Slide the Cable Clip to the mark. Figure 3 Figure 4 Step 5 Push end caps into place. 5 Step 6 Suspend poster. Figure 5 Figure 6 The AnoMultiTM and SlimTMare trademarks of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoMultiSQCableClipBallChain 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-7. 4. 02 AnoMultiTM Instruction Sheet Parts AnoMulti 12AM300SQ Cable Clips 06-5050 End Caps 06-5545 Ball Chains 96-0302P Instructions for Hanging Step 1 Insert the poster into the Slim Holder by either sliding the poster into the holder or tapping the holder onto the poster. 1 Note: For thinner substrates, it may be necessary to staple the edge of the graphic before inserting into Slim Holder. Step 2 Slide Slim holder into AnoMulti holder. 2 Figure 1 Figure 2 Step 3 Insert single ball of ball chain into inner channel of Cable Clip. 3 Step 4 Align one round end of cable clip with top channel of the aluminum rail and insert. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 4 Note: Be sure to slide the ball chain into place by pushing on the cable clip. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Figure 3 Figure 4 Step 5 Push end caps into place. 6 Figure 5 Figure 6 The AnoMultiTM and SlimTMare trademarks of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. [. . . ] Slide the Cable Clip to the mark. Figure 3 Figure 4 Step 5 Push end caps into place. 5 Step 6 Suspend poster. Figure 5 Figure 6 The AnoMultiTM and SlimTMare trademarks of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. [. . . ]