User manual ROSE DISPLAYS ANOQUICK SQUARE WITH CABLE CLIP AND BALL CHAIN

[. . . ] 1 Step 2 Starting at one corner, push the holder onto the graphic. Work your way down the holder tapping it down firmly to seat the graphic fully. 2 Figure 1 Figure 2 Step 3 Insert single ball of ball chain into inner channel of Cable Clip. [. . . ] 3 Step 4 Align one round end of cable clip with top channel of the aluminum rail and insert. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 4 Note: Be sure to slide the ball chain into place by pushing on the cable clip. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Note: For OneUp applications, the AnoQuick holder is conveniently marked in the center. Slide the Cable Clip to the mark. Figure 3 Figure 4 Step 5 Push end caps into place. 6 Figure 5 Figure 6 The AnoQuick is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoQuickSQCableClipBallChain 35 Congress Street, Salem, MA 01970 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-7. 4. 02 AnoQuickTM Parts Note: Use only with graphics mounted on 3/16" foamboard or other similar thickness. Can also use a folded edge thinner substrate. Square Profile Instruction Sheet AnoQuick 12A300SQ Cable Clips 06-5050 End Caps 06-5545 Ball Chains 96-0302P Instructions For Hanging Step 1 Prepare edges of graphic. Using the AnoQuick holder, run it across the graphic edge, crushing it slightly. 1 Step 2 Starting at one corner, push the holder onto the graphic. Work your way down the holder tapping it down firmly to seat the graphic fully. 2 Figure 1 Figure 2 Step 3 Insert single ball of ball chain into inner channel of Cable Clip. 3 Step 4 Align one round end of cable clip with top channel of the aluminum rail and insert. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 4 Note: Be sure to slide the ball chain into place by pushing on the cable clip. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Figure 3 Figure 4 Step 5 Push end caps into place. [. . . ] 4 Note: Be sure to slide the ball chain into place by pushing on the cable clip. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Note: For OneUp applications, the AnoQuick holder is conveniently marked in the center. [. . . ]