User manual ROTEL RA-06

[. . . ] WARNING: To reduce the risk of fire or electric shock, be sure that the apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. [. . . ] It provides information on how to incorporate the RA-06 into your system as well as information that will help you get optimum sound performance. Please contact your authorized Rotel dealer for answers to any questions you might have. in addition , all of us at Rotel welcome your questions and comments. Save the RA-06 shipping carton and all enclosed packing material for future use. Shipping or moving the RA-06 in anything other than the original packing material may result in severe damage to your amplifier. Fill out and send in the owner's registration card packed with the RA-06. It is your best record of the date of purchase, which you will need in the event warranty service is ever required. Be sure to keep the power cords, digital signal cables and regular audio signal cables in your installation away from each other. This will minimize the chance of the regular audio signal cables picking up noise or interference from the power cords or digital cables. Using only high quality, shielded cables will also help to prevent noise or interference from degrading the sound quality of your system. If you have any questions see your authorized Rotel dealer for advice about the best cable to use with your system. Once the RA-06 has been turned on with the front panel power switch, it can be switched between normal operating mode and standby mode with the Power button a on the RR-AT94 remote control. See the "12V Trigger Outlet" section for more information on ways you may be able to turn on and off other components in your system along with the RA-06. The polarity ­ the positive/negative orientation of the connections ­ for every speaker and amplifier connection must be consistent so all the speakers will be in phase. if the polarity of one connection is reversed , bass output will be very weak and stereo imaging degraded. The wire may have clear insulation with different color conductors (copper and silver). ] NOTE: To prevent loud noises that neither you nor your speakers will appreciate, make sure the system is turned off when you make any signal connections. The signal from the source selected with the Function Selector is always available from these outputs. Typically these outputs are used to provide a signal to another integrated amplifier or power amplifier, which is used to drive remote speakers. Plug the cable from the turntable into the appropriate left and right phono inputs. If the turntable has a "ground" wire connect it to the screw terminal to the left of the Phono inputs. The speaker outputs are controlled by the switch 7 on the front panel. [. . . ] If you believe this has happened, contact your authorized Rotel dealer to get the fuse replaced. Some audio components can be turned on automatically when they receive a 12V turn on "signal". When the RA-06 is in Standby mode, the trigger signal is interupted, so the components controlled by it are turned off. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. [. . . ]