User manual ROTEL RB-1072

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ROTEL RB-1072. We hope that this ROTEL RB-1072 user guide will be useful to you.


ROTEL RB-1072 : Download the complete user guide (3961 Ko)

You may also download the following manuals related to this product:

   ROTEL RB-1072 (1831 ko)

Manual abstract: user guide ROTEL RB-1072

Detailed instructions for use are in the User's Guide.

[. . . ] Connect the component to the power outlet only with the supplied power supply cable or an exact equivalent. Do not route the power cord where it will be crushed, pinched, bent at severe angles, exposed to heat, or damaged in any way. Pay particular attention to the power cord at the plug and where it exits the back of the unit. The mains plug is used as the mains disconnect device and shall remain readily accessible. [. . . ] A heavy duty multi-tap power outlet strip may be used, but only if it is rated to handle the current demand of the RB-1072. Be sure the Power Switch on the front panel of the RB-1072 is turned off. Then, plug one end of the cord into the AC power connector 8 on the back panel of the amplifier. Your RB-1072 is configured at the factory for the proper AC line voltage in the country where you purchased it (USA: 120 volts/60 Hz, Europe: 230 volts/50 Hz). NOTE: Should you move your RB-1072 to another country, it is possible to configure your amplifier for use on a different line voltage. Opening the enclosure of the RB-1072 exposes you to dangerous voltages. Consult a qualified technician or the Rotel factory service department for information. If you are going to be away from home for an extended period of time, it is a sensible precaution to unplug your amplifier. Turning the switch OFF cuts power to the amplifier, regardless of whether or not a trigger signal is present. See Figure 2 The RB-1072 has standard unbalanced RCAtype input connectors, the type used on nearly all audio equipment. These RCA inputs accept audio signals from preamplifiers or surround sound processors. To use this feature the adjacent switch 6 must be set in the 12V TRIG position (see previous section). This input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. See Figure 2 The RB-1072 has two sets of dual binding post speaker connection terminals, one set for each amplifier channel. Thermal and protection circuits protect the amplifier against potential damage in the event of extreme or faulty operating conditions. unlike many designs , the RB-1072's protection circuit is independent of the audio signal and has no impact on sonic performance. Instead, the protection circuit monitors the temperature of the output devices and shuts down the amplifier if safe limits are exceeded. In addition, the RB-1072 includes overcurrent protection which operates only when load impedances drop too low. Should a faulty condition arise, the amplifier will stop playing and the PROTECTION LED on the front panel will light. If this happens, turn the amplifier off, let it cool down for several minutes, and attempt to identify and correct the problem. [. . . ] If you are attaching bare wires directly to the speaker connectors, separate the wire conductors and strip back the insulation from the end of each conductor. Place the connector lug around the shaft, or insert the bundled wire into the hole in the shaft. turn the collars clockwise to clamp the connector lug or wire firmly in place. NOTE: Be sure there are no loose wire strands that could touch adjacent wires or connectors. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ROTEL RB-1072




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ROTEL RB-1072 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.