User manual ROTEL RC-06

[. . . ] WARNING: To reduce the risk of fire or electric shock, be sure that the apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. [. . . ] Your RC-06 is configured at the factory for the proper AC line voltage in the country where you purchased it (either 120 volts AC or 230 volts AC with a line frequency of either 50 Hz or 60 Hz). NOTE: Should you move your RC-06 amplifier to another country, it is possible to reconfigure it for use on a different line voltage. Consult a qualified service person or the Rotel factory service department for information. If you are going to be away from home for an extended period of time such as a month-long vacation, it is a sensible precaution to unplug your amplifier (as well as other audio and video components) while you are away. WARNING: To avoid potential damage to your system, turn off ALL the components in the system when connecting or disconnecting the loudspeakers or any associated components. Do not turn the system components back on until you are sure all the connections are correct and secure. There must be no loose strands that could contact the other speaker wires, or the chassis of the amplifier. It provides information on how to incorporate the RC-06 into your system as well as information that will help you get optimum sound performance. Please contact your authorized Rotel dealer for answers to any questions you might have. in addition , all of us at Rotel welcome your questions and comments. Save the RC-06 shipping carton and all enclosed packing material for future use. Shipping or moving the RC-06 in anything other than the original packing material may result in severe damage to your amplifier. Fill out and send in the owner's registration card packed with the RC-06. It is your best record of the date of purchase, which you will need in the event warranty service is ever required. Be sure to keep the power cords, digital signal cables and regular audio signal cables in your installation away from each other. This will minimize the chance of the regular audio signal cables picking up noise or interference from the power cords or digital cables. Using only high quality, shielded cables will also help to prevent noise or interference from degrading the sound quality of your system. If you have any questions see your authorized Rotel dealer for advice about the best cable to use with your system. The Power Indicator light above the Standby button is lit whenever the RC-06 is connected to a live AC outlet. When the front panel Standby button or the remote control Power button is pressed the RC-06 is turned on. When the RC-06 is on the Function indicator and the Volume control are illuminated. Pressing either button again puts the RC-06 in standby mode and turns off the Volume and Function illumination. [. . . ] When the Monitor Control is set to the Source position, the signal you hear, and which goes to the Outputs, is selected by the Function Control. to listen to the signal from a recorder connected to the Tape Inputs , set the Monitor Control to the Tape position. When the Monitor Control is in the Tape position, the signal from the Tape Input also goes to the Outputs. The signal that goes to the Tape Output is always selected by the Function Control. [. . . ]