User manual ROTEL RC-955

[. . . ] · Use only the supplied Power Unit and power cord with your Sony Wireless LAN Converter. To disconnect your Wireless LAN Converter from the power supply, unplug the Power Unit. · ISDN and telephone lines cannot be connected to the WIRELESS UNIT connector and/or NETWORK connector of the Power Unit. If these connectors are connected to the network or telephone lines mentioned below, high electric current to the connectors may cause damage, overheating, or fire. [. . . ] · L'installateur de cet appareil radio doit s'assurer que l'antenne soit située ou pointée de manière à ce qu'elle n'émette pas de champs électromagnétiques supérieurs aux limites spécifiées par Santé Canada à l'adresse suivante : http://www. hc-sc. gc. ca/rpb Getting help This section describes how to get help and support from Sony, as well as troubleshooting tips for your Wireless LAN Converter. About Sony's Support Options Sony provides several support options for your Wireless LAN Converter. Read This First (this manual) contains important information that you should read before using the Wireless LAN Converter. Quick Start Guide explains how to install the Wireless LAN Converter. Troubleshooting Guide provides solutions to the most common problems users encounter with their Wireless LAN Converter. Help for the Wireless LAN Converter Setup Page explains how to configure the Wireless LAN Converter. Wireless LAN Converter Setup Utility Help explains how to scan the Wireless LAN Converter. The Sony Wireless LAN Converter support Web site http://www. sony. com/wirelesslansupport provides the latest information on your Wireless LAN Converter. The Sony e-mail support service answers your questions by electronic mail. Just send your question in an e-mail message and a customer service representative will reply. To send a question to Sony e-mail support, fill out the e-mail form at http://www. ita. sel. sony. com/support/pc/email. html. The Sony fax-back service provides you with answers to commonly asked questions. Declaration of Conformity Trade Name: Sony Model No: RC-955 Responsible Party: Sony Electronics Inc. Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA Telephone: 201-930-6972 This phone number is for FCC-related matters only. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The shielded interface cable recommended in this manual must be used with the equipment to comply with the limits for a digital device pursuant to Subpart B of Part 15 of the FCC Rules and Canadian ICES-003. Le câble d'interface blindé recommandé dans ce document doit être utilisé avec les appareils pour être conforme aux limitations des appareils numériques telles que spécifiées dans la norme NMB-003 du Canada. NOTE: The power outlet should be installed near the equipment and should be easily accessible. Wireless LAN Converter Setup Page Help This is Help for the pages used to set up the 2. 4 GHz Wireless LAN Converter RC-955. Refer to it for details about setup page operations and the settings. Wireless LAN Converter Setup Utility Help This is Help for the Wireless LAN Converter Setup Utility software. Refer to it for details about Wireless LAN Converter Setup Utility operations. · Sony, VAIO, , and and the Eco Info logo are trademarks of Sony Corporation. · All other names of systems, products and services are trademarks of their respective owners. · In the manual, the TM or ® marks are not specified. Printed on 100% recycled paper using VOC (Volatile Organic Compound)-free vegetable oil based ink. Names of parts and functions Wireless Unit Front Rear (With rear cover removed) Installation Precautions Refer to the separate Quick Start Guide for information about connecting the Wireless Unit and Power Unit. Operating Precautions Power Unit Use the Power Unit supplied with the Wireless Unit. Using a different power unit may result in damage and/or injury. Installation Select a secure location for the Wireless Unit where it cannot drop or fall over. Route the cable to the Wireless Unit to suit the installation location. Safety Avoid exposing this product to strong impact, as it could result in damage. Installation examples · Desktop installation · Hanging Installation Do not install the Wireless LAN Converter where it is exposed to the following conditions. [. . . ] 7 MAC address label The Wireless LAN Converter MAC address is printed here. 8 Quick Setup switch Use this switch to configure the Wireless LAN Converter with the settings of the Wireless Broadband Router PCWA-AR300. Refer to the Quick Start Guide of the Wireless LAN Converter for details. qa NETWORK connector Connect the Wireless Unit to your computer or other device using an Ethernet cable. The Wireless Unit does not come with any sort of fittings used in hanging it. [. . . ]